B45025B1069K757 Kemet, B45025B1069K757 Datasheet - Page 25

• Manufacturer Part Number: B45025B1069K757
• Description: CAPACITOR, 10UF 25V B CASE CAPACITOR, 10UF 25V B CASE
• Manufacturer: Kemet
• Series: T495r

Specifications of B45025B1069K757

• Capacitance: 10UF
• Voltage Rating, Dc: 25V
• Capacitor Dielectric Type: TANTALUM
• Tolerance,: 10%
• Tolerance, -: 10%
• Temp, Op. Min: -55(DEGREE C)
• Temp, Op.: ROHS COMPLIANT

Low-resistance applications and voltage networks
For low-resistance applications, KEMET recommends a maximum operating voltage of half the
permissible maximum continuous voltage, so that the capacitors have sufficient tolerance to
withstand voltage peaks. Depending on the conditions of use, the early failure rate is higher here
by a factor of 2 to 20 than in the range with a constant failure rate as specified in the data book.
When operated directly in a voltage network, the capacitor should be protected against
overvoltage, e.g. by a suppressor diode, and against polarity reversal by a diode. If a capacitor is
operated in an unprotected low-impedance circuit and fails because the permissible conditions for
the forward DC voltage, reverse DC voltage, surge current, power dissipation or temperature are
exceeded, the continued current flow through the overstressed capacitor may produce
overheating. The overheated capacitor may damage the surrounding components and the circuit
board.
Storage conditions
Capacitors with solid electrolyte may be stored at temperatures down to –80 C. The upper
storage temperature must not exceed +85 C (for blister tape the temperature limit is +40 C).
The storage conditions should not exceed +40 C and 70% R. H. A drypack is useful to prevent
the effects of humidity.
Please read Important notes and
Cautions and warnings at the end of this document.
Tantalum chip capacitors
SpeedPower, Low ESR
Page 25 of 26
B45197A, B45198R, B450, B451