NHD-4.3-480272YF-ATXI#-1 Newhaven Display, NHD-4.3-480272YF-ATXI#-1 Datasheet - Page 27

• Manufacturer Part Number: NHD-4.3-480272YF-ATXI#-1
• Description: LCD Graphic Display Modules & Accessories 480 x 272 DPI 105.5 x 67 x 3.9 mm
• Manufacturer: Newhaven Display

Specifications of NHD-4.3-480272YF-ATXI#-1

• Pixel Density: 480 x 272
• Module Size (w X H X T): 105.7 mm x 67.4 mm x 4.15 mm
• Backlighting: LED White
• Operating Temperature Range: - 20 C to + 70 C
• Product: Graphic LCD Module
• Display Mode: Transmissive
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: NHD-4.3-480272YF-ATXI#-1T

11. General Precautions
(a) When the module is assembled, it should be attached to the system firmly. Be careful
(b) Refrain from strong mechanical shock and / or any force to the module. In addition to
(c) Note that polarizers are very fragile and could be easily damaged. Do not press or
(d) Wipe off water droplets or oil immediately. If you leave the droplets for a long time,
(e) If the surface of the polarizer is dirty, clean it using some absorbent cotton or soft
(f) The desirable cleaners are water, IPA(Isopropyl Alcohol) or Hexane. Do not use
(g) If the liquid crystal material leaks from the panel, it should be kept away from the
(h) Protect the module from static , it may cause damage to the Integrated Gate Circuit.
(i) Use finger-stalls with soft gloves in order to keep display clean during the incoming
(j) Do not disassemble the module.
(l) Protection film for polarizer on the module shall be slowly peeled off just before use
(m) Pins of I/F connector shall not be touched directly with bare hands
11.1 Handling
(k) Do not adjust the variable resistor which is located on the back side.
not to twist and bend the module.
damage, this may cause improper operation or damage to the module and back-light
unit.
scratch the surface harder than a HB pencil lead.
Staining and discoloration may occur.
cloth.
Ketone type materials(ex. Acetone), Ethyl alcohol, Toluene, Ethyl acid or Methyl
chloride. It might permanent damage to the polarizer due to chemical reaction.
eyes or mouth. In case of contact with hands, legs or clothes, it must be washed away
thoroughly with soap.
inspection and assembly process.
so that the electrostatic charge can be minimized.