DK-04D0-0394 LIGHTING SCIENCE GROUP CORPORATION, DK-04D0-0394 Datasheet - Page 3

• Manufacturer Part Number: DK-04D0-0394
• Description: LED Lighting Development Kits WHITE ATLAS SERIES Developer Kit-120VAC
• Manufacturer: LIGHTING SCIENCE GROUP CORPORATION

Specifications of DK-04D0-0394

• Supply Voltage: 120 V
• For Use With/related Products: BL-4000 series
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Operating Instructions
NOTE: Please unplug the AC power before connecting or disconnecting the LED Light Engine to avoid potential
damage to the Light Engine or the driver.
FM-0127 REV A 11.15.05
about your design, contact Lamina at 800.808.5822 or 609.265.1401 or visit www.laminaceramics.com.
1.
2.
3.
4.
To see how you can realize all these design benefits, to request a sample, or to speak with an engineer
Remove the Warm White Light Engine Assembly and driver from the kit case and place them on a suitable work surface near
an AC power outlet. Please verify the DC/DC connection cable is correctly attached between the light engine and driver.
Also, verify the AC power cord is properly connected to the driver. See the photos below for the proper connections.
Careful, Lamina LED Light Engines are extremely BRIGHT. Before powering up, direct the light engine away from
your eyes, place an optic over the light engine, or wear suitable protective eyewear. Plug the driver’s AC power cord
into a 120VAC/60Hz power outlet. The light engine will now be illuminating.
To test the included optics, insert the legs of the optic holder into the four corner holes in Lamina’s EZConnect board. The
EZConnect board is designed to align the optic to the center of the light engine and allow the optic to rest on the light engine
surface.
To try the White 5500K Light Engine Assembly, unplug the AC power and detach the DC/DC connection cable from the Warm
White Assembly. Plug the DC connection cable into the White 5500K Assembly per the DC Connection between Light Engine
and Driver photo below. Please refer to 2. and 3., directly above, for the power up and optics test procedure.
Quick View of Kit ready to power up
3