ABLS-13.560MHZ-10-R20-D Abracon Corporation, ABLS-13.560MHZ-10-R20-D Datasheet - Page 5

• Manufacturer Part Number: ABLS-13.560MHZ-10-R20-D
• Description: CRYSTAL 13.560MHZ 10PF SMD
• Manufacturer: Abracon Corporation
• Series: ABLS(RF)r
• Type: MHz Crystalr

Specifications of ABLS-13.560MHZ-10-R20-D

• Frequency: 13.56MHz
• Frequency Stability: ±50ppm
• Frequency Tolerance: ±50ppm
• Load Capacitance: 10pF
• Operating Mode: Fundamental
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: HC49/US
• Size / Dimension: 0.450" L x 0.190" W (11.40mm x 4.70mm)
• Height: 0.165" (4.20mm)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 535-9687-2

6.0 RELIABILITY TEST
6.1 REFLOW PROFILE
The Power Of Linking Together
No.
1
2
3
4
5
6
7
8
9
ABRACON
CORPORATION
Temperature Cycling:
Gross Leak Test:
Fine Leak Test:
Thermal Shock:
Solderability:
Test Items
(ABLS only)
Lead Bend:
Drop Test:
Vibration:
Humidity:
Drawing No. :
The component shall remain within the electrical specification (± 5 pp
max) after 3 cycles of high and low temperature testing (-40°C to
+85°C) for 2 hours max.
The component shall remain within the electrical specification after
exposure at extreme temperature -40°C to +85°C for 5 minutes for 3
cycles.
The component shall remain within the electrical specification after
loaded vibration at 10Hz to 55Hz, amplitude 1.5mm, within 1 minute
for 2 hours minimum on each axis (X,Y,Z).
The component shall remain within the electrical specifications after a
natural drop (3X) on a hard wooden board at 75 cm.
The component shall remain within the electrical specifications after
being kept at a condition of ambient temperature +85°C, 85% RH for
96 hours minimum.
Expose samples to 60PSIG Helium gas for 2 hours.
Max leak rate 2X10-8atmcc/s.
Submerge samples in 100% De-ionized water or Perfluorocarbon at
85°C for at least 1 minute. Check for bubbles.
Solderability of terminals shall be kept at more than 95% after dipped
in solder flux at 260°C ± 5°C for 5 seconds.
The component shall withstand maximum bend of 90°C
reference to base for 2 bends. Solder tinning must be
4 microns thick minimum.
-------
Test Conditions
Rev. -
Page 5 of 7