0638117500 Molex Inc, 0638117500 Datasheet - Page 4

• Manufacturer Part Number: 0638117500
• Manufacturer: Molex Inc
• Type: Hand Crimp Toolr

Specifications of 0638117500

• Lead Free Status / RoHS Status: RoHS Not Applicable

Hand Crimp Tool for “KK ” .156 Center Terminals
Doc No. ATS-638117500
Revision: C
4. Return the locator to its original position.
5. Insert the proper wire over the terminal. Gently touch the wire stop with the end of the wire. See Figure 3.
6. Compress the terminal by squeezing the tool handles until the ratchet mechanism cycle has been completed.
Note: The tamper proof ratchet action will not release the tool until it has been fully closed.
7. Remove the crimped terminal from the terminal locator by pressing down on the wire stop and gently pulling on
8. Visually inspect the crimped terminal for proper crimp location.
Note:
A crimp height chart is provided with this manual as Reference Only. Due to the wide range of wires, strands,
insulation diameters, and durometers, actual crimp height
measurements may very slightly. An occasional, destructive, pull
force test should be preformed to check hand tool crimp. Pull
Force value Must exceed the Minimum pull force specifications
listed on page 2 and 3.
Locator Change Over
Two styles of locators are provided with the crimp hand tool
63811-7500. They are 63811-7576, which is black and 63811-
7575, which is gray. Make sure the correct locator is installed for
the proper terminal and wire. Follow the steps below to change
the locators.
Release handles to open the jaws.
the wire. The terminal locator can be in either position.
OPEN WIRE STOP
PUSH HERE TO
LOCATOR
Figure 2
TERMINAL IN PLACE
Release Date: 12-06-06
Revision Date: 03-29-08
LOCATOR
TERMINAL
SWING OPEN
UNCONTROLLED COPY
AGAINST STOP
LOCATOR
IN PLACE
WIRE STOP
WIRE
WIRE STOP
BRASS PIVOT SHAFT
PRESS DOWN ON
LOCATOR
SWING
OPEN
Figure 3
LOCATOR
TERMINAL
LIFT UP
WIRE
Figure 4
Page 4 of 7
JAWS
OPEN