CDBCB455KCAY28-R0 Murata, CDBCB455KCAY28-R0 Datasheet - Page 28

• Manufacturer Part Number: CDBCB455KCAY28-R0
• Description: Signal Conditioning CDBCB455KCAY28-R0
• Manufacturer: Murata
• Type: Ceramic Discriminatorsr

Specifications of CDBCB455KCAY28-R0

• Rad Hardened: No
• Product: Ceramic Filters
• Operating Temperature Range: - 20 c to + 80 C
• Lead Free Status / RoHS Status: Compliant

!Note
• This PDF catalog is downloaded from the website of Murata Manufacturing co., ltd. Therefore, it’s specifications are subject to change or our products in it may be discontinued without advance notice. Please check with our
• This PDF catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
sales representatives or product engineers before ordering.
!Note
1. The component will be damaged when an excessive
2. The component may be damaged if excess mechanical
3. Design layout of components on the PC board to
4. After installing chips, if solder is excessively applied to
5. The component may be damaged during mounting
6. When correcting chips with a soldering iron, the tip of the
7. Do not clean or wash the component as it is not
8. In case of covering filter with over coat, conditions such
9. Do not use strong acidity flux, more than 0.2wt% chlorine
10. Accurate test circuit values are required to measure
11. For safety purposes, connect the output of filters to the
SFECS10M8 Series Notice (Handling)
stress is applied.
stress is applied to it mounted on the printed circuit
board.
minimize the stress imposed on the warp or flexure of the
board.
the circuit board, mechanical stress will cause destruction
resistance characteristics to lower. To prevent this, be
extremely careful in determining shape and dimension
before designing the circuit board diagram.
process if some part of mounter such as positioning
claws, nozzle are worn down. The regular maintenance
recommended for mounters should be done to prevent
the troubles.
soldering iron should not directly touch the chip
component. Depending on the soldering conditions, the
effective area of terminations may be reduced. The use
of solder containing Ag should be done to prevent the
electrode erosion.
hermetically sealed.
as material of resin, cure temperature, and so on should
be evaluated carefully.
content, in re-flow soldering.
Continued from the preceding page.
electrical characteristics.
It may be a cause of mis-correlation if there is any
deviation, especially stray capacitance, from the test
circuit in the specification.
IF amplifier through a D.C. blocking capacitor. Avoid
applying a direct current to the output of ceramic filters.
• Please read rating and !CAUTION (for storage, operating, rating, soldering, mounting and handling) in this catalog to prevent smoking and/or burning, etc.
• This catalog has only typical specifications because there is no space for detailed specifications. Therefore, please approve our product specifications or transact the approval sheet for product specifications before ordering.
[Component layout close to board]
MHz SMD Type CERAFILr Notice
Perforation
A
B
Slit
C
Continued on the following page.
Susceptibility to
stress is in the order
of; A>C>B
27
P05E.pdf
06.2.13
9