M1-SYSMGMT-DEV-KIT-FP3 Actel, M1-SYSMGMT-DEV-KIT-FP3 Datasheet - Page 25

• Manufacturer Part Number: M1-SYSMGMT-DEV-KIT-FP3
• Description: MCU, MPU & DSP Development Tools System Management Development Kit
• Manufacturer: Actel

Specifications of M1-SYSMGMT-DEV-KIT-FP3

• Processor To Be Evaluated: AFS1500-FG484
• Interface Type: RS-232, USB
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Digital Brick
VIN_D
DIG_BRK_OUT
VSENSE
M1 System Management Board User’s Guide
for EXT_VOL[3]. Identical switch positions are used for common division factors across all three switches. The table
below applies to any switch.
Note:
You can connect a digital brick on the board. The following signals are common to all digital bricks.
This is the input power to the digital brick. Use alligator clips to connect the VIN_D pin to the input supply of the
digital brick. This pin can provide 9-12 V, depending on the input supply used for the System Management Board.
This is the output voltage of the digital brick. This voltage is monitored by the M1AFS1500-FG484 device using the
AV pads.
This pin is an input to the digital brick that senses back the output voltage of the brick
(Figure
If an external board has voltages greater than 12 V that need to be monitored, use these options to apply the right
range of voltage to the AV pad.
2-11).
1
2
3
4
Numerical Switch Position
Table 2-19 · Switch Settings
Figure 2-11. VSENSE
Internal Voltage as Factor of External Voltage Vext
Vext * 1/2
Vext * 1/4
Vext * 1/8
Vext * 1
DIG_BRK_OUT
VSENSE
Digital Brick
25