AD7890AR-4 Analog Devices Inc, AD7890AR-4 Datasheet - Page 19

• Manufacturer Part Number: AD7890AR-4
• Description: IC,Data Acquisition System,8-CHANNEL,12-BIT,SOP,24PIN,PLASTIC
• Manufacturer: Analog Devices Inc
• Type: Data Acquisition System (DAS)r

Specifications of AD7890AR-4

• Rohs Status: RoHS non-compliant
• Resolution (bits): 12 b
• Sampling Rate (per Second): 117k
• Data Interface: Serial
• Voltage Supply Source: Single Supply
• Voltage - Supply: 0 V ~ 4.10 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 24-SOIC (7.5mm Width)

SIMPLIFYING THE INTERFACE
To minimize the number of interconnect lines to the AD7890,
the user can connect the RFS and TFS lines of the AD7890
together and read and write from the part simultaneously. In
this case, new control register data should be provided on the
DATA IN line selecting the input channel and possibly
providing a conversion start command while the part provides
the result from the conversion just completed on the
DATA OUT line.
In the self-clocking mode, this means that the part provides all
the signals for the serial interface. It does require that the
microprocessor has the data to be written to the control register
available in its output register when the part brings the TFS line
low. In the external clocking mode, it means that the user only
has to supply a single frame synchronization signal to control
both the read and write operations.
Rev. C | Page 19 of 28
Care must be taken with this scheme that the read operation is
completed before the next conversion starts, if the user wants to
obtain optimum performance from the part. In the case of the
software conversion start, the conversion command is written
to the control register on the sixth serial clock edge. However,
the read operation continues for another 10 serial clock cycles.
To avoid reading during the sampling instant or during
conversion, the user should ensure that the internal pulse width
is sufficiently long (by choosing C
is completed before the next conversion sequence begins.
Failure to do this results in significantly degraded performance
from the part, both in terms of signal-to-noise ratio and dc
parameters. In the case of a hardware conversion start, the user
should ensure that the delay between the sixth falling edge of
the serial clock in the write operation and the next rising edge
of CONVST is greater than the internal pulse width.
EXT
) so that the read operation
AD7890