AD8599ARZ-REEL7 Analog Devices Inc, AD8599ARZ-REEL7 Datasheet - Page 4

• Manufacturer Part Number: AD8599ARZ-REEL7
• Description: IC,Operational Amplifier,DUAL,SOP,8PIN,PLASTIC
• Manufacturer: Analog Devices Inc

Specifications of AD8599ARZ-REEL7

• Design Resources: Using AD8599 as an Ultralow Distortion Driver for the AD7991 (CN0043) Using AD8599 as an Ultralow Distortion Driver for the AD7995 (CN0044) Using AD8599 as an Ultralow Distortion Driver for the AD7999 (CN0045) High Speed Instrumentation Amplifier Using AD8271 and ADA4627-1 (CN0122)
• Amplifier Type: General Purpose
• Number Of Circuits: 2
• Slew Rate: 16 V/µs
• Gain Bandwidth Product: 10MHz
• Current - Input Bias: 25nA
• Voltage - Input Offset: 10µV
• Current - Supply: 5mA
• Current - Output / Channel: 52mA
• Voltage - Supply, Single/dual (±): 9 V ~ 36 V, ±4.5 V ~ 18 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: 8-SOIC (3.9mm Width)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Output Type: -
• -3db Bandwidth: -
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AD8599
ABSOLUTE MAXIMUM RATINGS
Table 2.
Parameter
Supply Voltage
Input Voltage
Differential Input Voltage
Output Short-Circuit to GND
Storage Temperature Range
Operating Temperature Range
Lead Temperature Range (Soldering 60 sec)
Junction Temperature
Stresses above those listed under Absolute Maximum Ratings
may cause permanent damage to the device. This is a stress
rating only; functional operation of the device at these or any
other conditions above those indicated in the operational
section of this specification is not implied. Exposure to absolute
maximum rating conditions for extended periods may affect
device reliability.
Rating
±18 V
GND to V
±1 V
Indefinite
−65°C to +150°C
−40°C to +125°C
300°C
150°C
DD
Rev. A | Page 4 of 16
THERMAL RESISTANCE
θ
soldered in a circuit board for surface-mount packages.
Table 3. Thermal Resistance
Package Type
8-Lead SOIC (R-8)
POWER SEQUENCING
The op amp supplies must be established simultaneously with,
or before, any input signals are applied.
If this is not possible, the input current must be limited to 10 mA.
ESD CAUTION
JA
is specified for the worst-case conditions, that is, a device
θ
120
JA
θ
36
JC
Unit
°C/W