AD9218BSTZ-RL40 Analog Devices Inc, AD9218BSTZ-RL40 Datasheet - Page 11

• Manufacturer Part Number: AD9218BSTZ-RL40
• Description: IC,A/D CONVERTER,DUAL,10-BIT,CMOS,QFP,48PIN
• Manufacturer: Analog Devices Inc

Specifications of AD9218BSTZ-RL40

• Number Of Bits: 10
• Sampling Rate (per Second): 40M
• Data Interface: Parallel
• Number Of Converters: 2
• Power Dissipation (max): 340mW
• Voltage Supply Source: Analog and Digital
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 48-LQFP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• For Use With: AD9218-65PCB - BOARD EVAL FOR AD9218-65
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Signal-to-Noise and Distortion (SINAD)
The ratio of the rms signal amplitude (set 1 dB below full scale)
to the rms value of the sum of all other spectral components,
including harmonics but excluding dc.
Signal-to-Noise Ratio (without Harmonics)
The ratio of the rms signal amplitude (set at 1 dB below full
scale) to the rms value of the sum of all other spectral
components, excluding the first five harmonics and dc.
Spurious-Free Dynamic Range (SFDR)
The ratio of the rms signal amplitude to the rms value of the
peak spurious spectral component. The peak spurious component
may or may not be a harmonic. Reported in dBc (that is,
degrades as signal level is lowered) or dBFS (always related back
to converter full scale).
Two-Tone Intermodulation Distortion Rejection
The ratio of the rms value of either input tone to the rms value
of the worst third-order intermodulation product; reported in dBc.
Rev. C | Page 11 of 28
Two-Tone SFDR
The ratio of the rms value of either input tone to the rms value
of the peak spurious component. The peak spurious component
may or may not be an IMD product. Reported in dBc (that is,
degrades as signal level is lowered) or in dBFS (always related
back to converter full scale).
Worst Other Spur
The ratio of the rms signal amplitude to the rms value of the
worst spurious component (excluding the second and third
harmonics) reported in dBc.
Transient Response Time
Transient response is defined as the time it takes for the ADC to
reacquire the analog input after a transient from 10% above
negative full scale to 10% below positive full scale.
Out-of-Range Recovery Time
Out-of-range recovery time is the time it takes for the ADC to
reacquire the analog input after a transient from 10% above
positive full scale to 10% above negative full scale or from 10%
below negative full scale to 10% below positive full scale.
AD9218