D4N-1132 Omron, D4N-1132 Datasheet - Page 20

• Manufacturer Part Number: D4N-1132
• Description: Switch
• Manufacturer: Omron
• Series: D4Nr
• Type: Snap Action Safety Limitr

Specifications of D4N-1132

• Operating Force Max: 6.5N
• Contact Voltage Ac Max: 240V
• Contact Voltage Dc Max: 250V
• Contact Current Ac Max: 10A
• Contact Current Dc Max: 2.5A
• Switch Terminals: Screw
• Svhc: No SVHC (15-Dec-2010)
• Contact Form: 1 NC / 1 NO
• Contact Rating: 10 Amps at 120 VoltsAC, 240 VoltsAC
• Actuator: Roller Plunger
• Operating Force: 6.5 N
• Termination Style: Conduit
• Ingress Protection: IP67
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

Recommended Connectors
Use connectors with screws not exceeding 9 mm, otherwise the
screws will protrude into the case interior, interfering with other
components in the case.
The connectors listed in the following table have connectors with
thread sections not exceeding 9 mm.
Use the recommended connectors to ensure conformance to IP67.
Use LAPP connectors together with seal packing (JPK-16, GP-13.5,
or GPM20), and tighten to the specified tightening torque. Seal
packing is sold separately.
Others
G1/2
Pg13.5
M20
1/2-14NPT
• LAPP is a German manufacturer.
• Before using a 2-conduit 1/2-14NPT type, attach the provided
• When attaching a cover, be sure that the seal rubber is in place and
• Do not use any screws to connect the cover other than the
• Make sure that foreign particles do not enter the head when
• Use the following recommended countermeasures to prevent
changing adaptor to the Switch and then connect the
recommended connector.
that there is no foreign material present. If the cover is attached
with the seal rubber out of place or if foreign material is stuck to the
rubber, a proper seal will not be obtained.
specified ones. The seal characteristics may be reduced.
removing the screws from the four corners to change the head
position in any of the four directions.
telegraphing when using adjustable or long levers.
1. Make the rear edge of the dog smooth with an angle of 15° to
2. Design the circuit so that no error signal will be generated.
Size
30° or make it in the shape of a quadratic curve.
LAPP
LAPP
LAPP
LAPP
Manufacturer
ST-PF1/2
5380-1002
ST-13.5
5301-5030
ST-M20 × 1.5
5311-1020
ST-NPT1/2
5301-6030
Model
6.0 to 12.0 mm
6.0 to 12.0 mm
7.0 to 13.0 mm
6.0 to 12.0 mm
Applicable cable
diameter
D4N
20