MAX194BCWE Maxim Integrated Products, MAX194BCWE Datasheet - Page 7

• Manufacturer Part Number: MAX194BCWE
• Description: Audio A/D Converter ICs Integrated Circuits (ICs)
• Manufacturer: Maxim Integrated Products

Specifications of MAX194BCWE

• Conversion Rate: 85 KSPs
• Resolution: 14 bit
• Number Of Adc Inputs: 1
• Maximum Operating Temperature: + 70 C
• Minimum Operating Temperature: 0 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

If the power supplies do not settle within the MAX194’s
power-on delay (500ns minimum), power-up calibration
may begin with supply voltages that differ from the final
values and the converter may not be properly calibrat-
ed. If so, recalibrate the converter (pulse RESET low)
before use. For best DC accuracy, calibrate the
MAX194 any time there is a significant change in sup-
ply voltages, temperature, reference voltage, or clock
characteristics (see External Clock section) because
these parameters affect the DC offset. If linearity is the
only concern, much larger changes in these parame-
ters can be tolerated.
Because the calibration data is stored digitally, there is
no need either to perform frequent conversions to main-
tain accuracy or to recalibrate if the MAX194 has been
held in shutdown for long periods. However, recalibra-
tion is recommended if it is likely that supply voltages or
ambient temperature has significantly changed since
the previous calibration.
The digital interface pins consist of BP/UP/SHDN, CLK,
SCLK, EOC, CS, CONV, and RESET.
BP/UP/SHDN is a three-level input. Leave it floating to
configure the MAX194’s analog input in bipolar mode
(AIN = -V
Figure 3. Initiating Conversions—At least 3 CLK cycles since end of previous conversion.
TRACK/HOLD
CONV
REF
EOC
CLK
to V
14-Bit, 85ksps ADC with 10µA Shutdown
REF
_______________________________________________________________________________________
) or connect it high for a unipolar
CONVERSION
ENDS
Digital Interface
*
THE FALLING EDGE OF CONV MUST OCCUR IN THIS REGION
t
CEL
t
AQ
t
CC1
input (AIN = 0V to V
places the MAX194 in its 10µA shutdown mode.
A logic low on RESET halts MAX194 operation. The ris-
ing edge of RESET initiates calibration as described in
the Calibration section above.
Begin a conversion by bringing CONV low. The convert
signal must be synchronized with CLK. The falling edge
of CONV must occur during the period shown in
Figures 3 and 4. When CLK is not directly controlled by
your processor, two methods of ensuring synchroniza-
tion are to drive CONV from EOC (continuous conver-
sions) or to gate the conversion-start signal with the
conversion clock so that CONV can go low only while
CLK is low (Figure 5). Ensure that the maximum propa-
gation delay through the gate is less than 40ns.
The MAX194 automatically ensures four CLK periods
for track/hold acquisition. If, when CONV is asserted, at
least three clock (CLK) cycles have passed since the
end of the previous conversion, a conversion will begin
on CLK’s next falling edge and EOC will go high on the
following falling CLK edge (Figure 3). After conversion
begins, additional convert start pulses are ignored. If,
when convert is asserted, less than three clock cycles
have passed, a conversion will begin on the fourth
falling clock edge after the end of the previous conver-
*
CONVERSION
BEGINS
t
CC2
t
CW
REF
). Bringing BP/UP/SHDN low
t
CEH
7