DMG-400 PRO SIGNAL, DMG-400 Datasheet
DMG-400
Manufacturer Part Number
DMG-400
Description
GOOSENECK MIC, BARE ENDS
Manufacturer
PRO SIGNAL
Datasheet
1.DMG-400.pdf
(1 pages)
Specifications of DMG-400
Transducer Function
Microphone
Device Type
Gooseneck Microphone
Connector Type
3 Bare Wire End
Sensitivity
2.2mV/Pa/1kHz
Output Impedance
500ohm
External Diameter
28mm
External Length / Height
385mm
DMG-400
DMG-600
Specifications
Disclaimer This data sheet and its contents (the "Information") belong to the Premier Farnell Group (the "Group") or are licensed to it. No licence is granted for the use of it other than for information purposes
in connection with the products to which it relates. No licence of any intellectual property rights is granted. The Information is subject to change without notice and replaces all data sheets previously supplied.
The Information supplied is believed to be accurate but the Group assumes no responsibility for its accuracy or completeness, any error in or omission from it or for any use made of it. Users of this data
sheet should check for themselves the Information and the suitability of the products for their purpose and not make any assumptions based on information included or omitted. Liability for loss or damage
resulting from any reliance on the Information or use of it (including liability resulting from negligence or where the Group was aware of the possibility of such loss or damage arising) is excluded.
This will not operate to limit or restrict the Group's liability for death or personal injury resulting from its negligence. SPC pro-SIGNAL is the registered trademark of the Group. © Premier Farnell plc 2009.
Gooseneck MIC, Bare Ends
Gooseneck Mic
http://www.farnell.com
http://www.newark.com
http://www.cpc.co.uk
Gooseneck MIC, XLR
Description
3 Bare Wire Ends
Termination
XLR socket
Feature:
• A range of gooseneck microphones either terminating in 3-bare wire ends or
with a balanced XLR plug.
(Hz to kHz)
Frequency
Response
200 to 12
Page 1
(mV/Pa/kHz)
Sensitivity
2.2/1
2/1
Impedance
(Ohms)
500
(L x Diameter)
Dimensions
385 x 28
565 x 21
Dimensions : Millimetres
04/06/09 V1.0
Part Number
DMG-400
DMG-600
Related parts for DMG-400
Image
Part Number
Description
Manufacturer
Datasheet
Request
R
Part Number:
Description:
GOOSENECK MIC, XLR
Manufacturer:
PRO SIGNAL
Datasheet:
Part Number:
Description:
VOCAL MICROPHONE
Manufacturer:
PRO SIGNAL
Datasheet:
Part Number:
Description:
PIEZO SIREN, 12VDC
Manufacturer:
PRO SIGNAL
Datasheet:
Part Number:
Description:
PATCH LEAD, CAT 5E, 7M GREY
Manufacturer:
PRO SIGNAL
Datasheet: