162GB10F1412PN608 Amphenol PCD, 162GB10F1412PN608 Datasheet - Page 31

• Manufacturer Part Number: 162GB10F1412PN608
• Description: Conn MIL-C-26482 Circular PIN 12 POS Crimp ST Wall Mount 12 Terminal 1 Port
• Manufacturer: Amphenol PCD
• Type: MIL-C-26482 Circularr

Specifications of 162GB10F1412PN608

• Gender: RCP
• Termination Method: Crimp
• Mounting: Wall Mount
• Body Orientation: Straight

NOTE: After assembly, braid can be trimmed with side cutters
Prepare the cable making sure that a sufficient length of shield is available, so that it fits against the front shoulder of the lip groove.
Before insertion of connector contacts, slide the heat-shrinkable connector boot onto the cable followed by the Spring Adapter.
Position the heatshrinkable boot, Spring Adapter, and shield braid out of the way and insert the connector contacts.
Depending upon the shielding braid size, it can either be folded back onto itself or bunched up concertina style out of the way
for easy access to the cable conductors.
Screw the Spring Adapter onto the connector and tighten to the torque value specified by the connector manufacturer. Typical
torque values are shown in table on Page 7. It is recommended that the connector threads are lubricated with a suitable
compound if a liquid thread lock is not used. The adapter should be hand tightened to ensure proper thread alignment and
then tightened with a strap wrench and torque meter to the specified torque.
Open up the constant force spring and wrap it around the cable braid section that is positioned over the constant force spring
slot area of the adapter. This is most easily accomplished by lifting up the end of the spring and trapping the braid covered
adapter between the spring coil and raised end. The spring will now stay in place and can be installed by simply rolling the
Bring the cable shield braid up onto the adapter body so that it fits against the front shoulder of the lip groove. Alternatively
extend the braid past the lip groove.
coil around the braid covered adapter. Refer to appropriate code of practice for procedure to install heatshrink shape.
or folded back and secured with high temperature tape
Lift Up End of Spring
between Spring Coil and raised
Trap Braid Covered Adapter
end
Interconnection Accessories
Fold Cable Braid back
INSTALLATION - PROCEDURE
Roll Spring Coil around
Secure Cable Braid
End with Tape
Adapter
31