5962-9080303MLA QP SEMICONDUCTOR, 5962-9080303MLA Datasheet - Page 3

• Manufacturer Part Number: 5962-9080303MLA
• Manufacturer: QP SEMICONDUCTOR

Specifications of 5962-9080303MLA

• Lead Free Status / RoHS Status: Supplier Unconfirmed

DSCC FORM 2234
APR 97
part of this drawing to the extent specified herein. Unless otherwise specified, the issues of these documents are those cited in
the solicitation or contract.
(Copies of these documents are available online at
Standardization Document Order Desk, 700 Robbins Avenue, Building 4D, Philadelphia, PA 19111-5094.)
_______
1/
2/
3/
1.3 Absolute maximum ratings. 1/
1.4 Recommended operating conditions.
2. APPLICABLE DOCUMENTS
Supply voltage range to ground potential (V
DC voltage applied to the outputs in the high-Z state ................ -0.5 V dc to +7.0 V dc
DC input voltage ....................................................................... -3.0 V dc to +7.0 V dc
DC program voltage .................................................................. 13.0 V dc
Maximum power dissipation ....................................................... 1.0 W 2/
Lead temperature (soldering, 10 seconds) ................................ +260°C
Thermal resistance, junction-to-case (θ
Junction temperature (T
Storage temperature range (T
Supply voltage (V
Ground voltage (GND) .............................................................. 0 V dc
Input high voltage (V
Input low voltage (V
Case operating temperature range (T
DEPARTMENT OF DEFENSE SPECIFICATION
DEPARTMENT OF DEFENSE STANDARDS
DEPARTMENT OF DEFENSE HANDBOOKS
Stresses above the absolute maximum rating may cause permanent damage to the device. Extended operation at the
maximum levels may degrade performance and affect reliability.
Must withstand the added P
V
IL
2.1 Government specification, standards, and handbooks. The following specification, standards, and handbooks form a
MIL-PRF-38535 - Integrated Circuits, Manufacturing, General Specification for.
MIL-STD-883
MIL-STD-1835 -
MIL-HDBK-103 -
MIL-HDBK-780 -
negative undershoots to a minimum of -3.0 V dc are allowed for pulse widths < 10 ns.
DEFENSE SUPPLY CENTER COLUMBUS
MICROCIRCUIT DRAWING
COLUMBUS, OHIO 43218-3990
CC
STANDARD
-
) ................................................................. +4.5 V dc minimum to +5.5 V dc maximum
IL
IH
) ............................................................... 0.8 V dc maximum 3/
Test Method Standard Microcircuits.
Interface Standard Electronic Component Case Outlines.
List of Standard Microcircuit Drawings.
Standard Microcircuit Drawings.
) .............................................................. 2.0 V dc minimum
J
) .......................................................... +175°C
D
due to short circuit test; e.g., I
STG
) ............................................ -65°C to +150°C
C
) .................................... -55°C to +125°C
JC
) ................................ See MIL-STD-1835
CC
) ......................... -0.5 V dc to +7.0 V dc
http://assist.daps.dla.mil/quicksearch/
OS
.
SIZE
A
REVISION LEVEL
or
http://assist.daps.dla.mil
C
SHEET
5962-90803
or from the
3