TSOP1756 Vishay, TSOP1756 Datasheet - Page 3

no-image

TSOP1756

Manufacturer Part Number
TSOP1756
Description
Manufacturer
Vishay
Datasheet

Specifications of TSOP1756

Operating Supply Voltage (typ)
5V
Operating Supply Voltage (min)
4.5V
Operating Supply Voltage (max)
5.5V
Mounting
Through Hole
Pin Count
3
Operating Temperature Classification
Commercial
Lead Free Status / RoHS Status
Compliant

Available stocks

Company
Part Number
Manufacturer
Quantity
Price
Part Number:
TSOP1756
Manufacturer:
VISHAY
Quantity:
50 750
Part Number:
TSOP1756
Manufacturer:
VISHAY
Quantity:
7 490
Suitable Data Format
The circuit of the TSOP17.. is designed in that way that
unexpected output pulses due to noise or disturbance
signals are avoided. A bandpassfilter, an integrator
stage and an automatic gain control are used to
suppress such disturbances.
The distinguishing mark between data signal and
disturbance signal are carrier frequency, burst length
and duty cycle.
The data signal should fullfill the following condition:
frequency of the bandpass (e.g. 38kHz).
cycles a gap time of at least 14 cycles is neccessary.
corresponding gap time is necessary at some time in
the data stream. This gap time should have at least
same length as the burst.
continuously.
Document Number 82030
Rev. 10, 02-Apr-01
Carrier frequency should be close to center
Burst length should be 10 cycles/burst or longer.
After each burst which is between 10 cycles and 70
For each burst which is longer than 1.8ms a
Up to 1400 short bursts per second can be received
0
IR Signal from Fluorescent Lamp with low Modulation
5
time [ms]
10
Some examples for suitable data format are:
NEC Code, Toshiba Micom Format, Sharp Code, RC5
Code, RC6 Code, R–2000 Code, Sony Format
(SIRCS).
When a disturbance signal is applied to the TSOP17..
it can still receive the data signal. However the
sensitivity is reduced to that level that no unexpected
pulses will occure.
Some examples for such disturbance signals which
are suppressed by the TSOP17.. are:
frequency
ballast (an example of the signal modulation is in the
figure below).
DC light (e.g. from tungsten bulb or sunlight)
Continuous signal at 38kHz or at any other
Signals from fluorescent lamps with electronic
15
Vishay Semiconductors
TSOP17..
www.vishay.com
20
3 (7)

Related parts for TSOP1756