S2S3LB Sharp Electronics, S2S3LB Datasheet - Page 9

• Manufacturer Part Number: S2S3LB
• Manufacturer: Sharp Electronics

Specifications of S2S3LB

• Number Of Elements: 1
• Forward Voltage: 1.4V
• Repetitive Peak Off-state Volt: 600V
• Operating Temp Range: -30C to 100C
• Output Current: 50mA
• Package Type: Mini Flat
• Reverse Breakdown Voltage: 6V
• Mounting: Surface Mount
• Pin Count: 4
• Trigger Current: 5mA
• Zero Crossing Circuit: No
• Operating Temperature Classification: Commercial
• Forward Current: 50mA
• Output Device: Triac
• Isolation Voltage: 3750Vrms
• Lead Free Status / RoHS Status: Not Compliant

■ Design Considerations
● Degradation
● Recommended Foot Print (reference)
● Design guide
In order for the Phototriac to turn off, the triggering current (I
Please refrain from using these devices in a direct drive configuration.
These Phototriac Coupler are intended to be used as triggering device for main Triacs.
Please ensure that the output rating of these devices will be sufficient for triggering the main output Triac of
your choice. Failure to do may result in malfunctions.
In phase control applications or where the Phototriac Coupler is being by a pulse signal, please ensure that
the pulse width is a minimum of 1ms.
For designs that will experience excessive noise or sudden changes in load voltage, please include an
appropriate snubber circuit as shown in the below circuit.
Please keep in mind that Sharp Phototriac Couplers incorporate superor dV/dt ratings which can often
eliminate the need for a snubber circuit.
In general, the emission of the IRED used in Phototriac Couplers will degrade over time.
In the case where long term operation and / or constant extreme temperature fluctuations will be applied to
the devices, please allow for a worst case scenario of 50% degradation over 5years.
Therefore in order to maintain proper operation, a design implementing these Phototriac Couplers should
provide at least twice the minimum required triggering current from initial operation.
1.5
9
6.3
F
), must be 0.1mA or less.
Sheet No.: D2-A06501EN
S2S3 Series
(Unit : mm)