F3M-S1225 Omron, F3M-S1225 Datasheet - Page 6

• Manufacturer Part Number: F3M-S1225
• Description: Sensor Hardware & Accessories Comb Sensor 25 SLOT 12
• Manufacturer: Omron

Specifications of F3M-S1225

• Output Type: *
• Sensor Type: *
• Lead Free Status / RoHS Status: Supplier Unconfirmed

J F3M-S1213
Precautions
J CORRECT USE
Avoid Damage to the F3M-S
•
•
•
•
J INSTALLATION/ENVIRONMENT
Do NOT use the F3M-S in the following places:
•
•
•
•
J CONNECTION AND MOUNTING
•
•
•
F3M-S
Optical axis
RUN/TEACH mode selector
Teaching button
Do not use the F3M-S at a voltage that exceeds the rated
voltage range.
Do not make mistakes in wiring, such as mistakes in polarity.
Do not short-circuit the load.
Do not connect AC to the F3M-S.
Places exposed to direct sunlight.
Places with high humidity that may cause condensation.
Places with corrosive gas.
Places with vibration or shock directly affecting the Sensor.
A maximum of 24 VDC+10% can be imposed on the F3M-S.
Check that the voltage of the power supply is within the per-
missible range before turning on the F3M-S. The power sup-
ply must be constructed so that the secondary circuit is insu-
lated with an isolating transformer.
Do not wire power lines or high-tension lines within the same
conduit with the lines of the F3M-S, or the F3M-S may be
damaged or malfunction due to induction. You must wire the
lines of the F3M-S separate from power lines or high-tension
lines or laid in an separate, shielded conduit.
Avoid mechanical impact when mounting the F3M-S, or the
water-resistant properties of the F3M-S will be reduced.
25 (0.98)
18 (0.71)
(1.97)
50
140 (5.51)
Power indicator
Teaching indicator
Warning indicator
Two, M4, depth: 8
(mounting holes)
OMRON XG4A-3034
Connector
Optical axis
Optical axis
7
Optical axis
18 (0.71)
25 (0.98)
(1.97)
50
RUN/TEACH mode selector
J F3M-S1225
J CLEANING
Do not attempt to clean the F3M-S using paint thinner, to avoid
damaging the surface of the F3M-S.
J POWER SUPPLY
If a standard switching power supply is connected to the F3M-S,
be sure to ground the FG (frame ground) and G (ground)
terminals of the power supply. The F3M-S may malfunction due
to switching noise that will be generated from the power supply if
these terminals are not grounded.
Teaching button
260 (10.24)
Power indicator
Teaching indicator
Warning indicator
OMRON XG4A-3034
Connector
Two, M4, depth: 8
(mounting holes)
Optical axis
Optical axis
F3M-S