4304-00 Peregrine Semiconductor, 4304-00 Datasheet
4304-00
Specifications of 4304-00
4304-0
Related parts for 4304-00
4304-00 Summary of contents
Page 1
... Product Description The PE4304 is a 75-ohm high-linearity, 6-bit RF Digital Step Attenuator (DSA) covering a 31.5 dB attenuation range in 0.5 dB steps. The PE4304 provides both a parallel (latched or direct mode) and serial CMOS control interface, operates on a single 3-volt supply and maintains high attenuation accuracy over frequency and temperature ...
Page 2
... Table 3. Latch-Up Avoidance Unlike conventional CMOS devices, UltraCMOS™ devices are immune to latch-up. Switching Frequency The PE4304 has a maximum 25 kHz switching rate. Resistor on Pin 1 & kΩ resistor on the inputs to Pin 1 & 3 (see DD. Figure 5) will eliminate package resonance between ) to bypass and the RF input pin and the two digital inputs ...
Page 3
... PE4304 Product Specification Evaluation Kit The Digital Attenuator Evaluation Kit board was designed to ease customer evaluation of the PE4304 Digital Step Attenuator used in conjunction with the supplied DC cable to supply V , GND, and – use of the internal DD DD negative voltage generator is desired, then do not connect – ...
Page 4
... Figure 9. Output Return Loss at Major 1200 1600 2000 Product Specification 2dB 1dB 0.5dB 400 800 1200 RF Frequency (MHz) Attenuation Steps 0 -5 -10 -15 -20 -25 -30 -35 0 400 800 1200 RF Frequency (MHz) Document No. 70-0066-04 │ UltraCMOS™ RFIC Solutions PE4304 31.5dB 16dB 8dB 4dB 1600 2000 1600 2000 ...
Page 5
... PE4304 Product Specification Typical Performance Data @ 25°C, V Figure 10. Attenuation Error Vs. Frequency 1 0.5 0 -0 400 800 RF Frequency (MHz) Figure 12. Attenuation Error Vs. Attenuation Setting 0.6 0.4 0.2 0 -0.2 -0 Attenuati on Setting (dB) Note: Positive attenuation error indicates higher attenuation than target value Document No. 70-0066-04 │ www.psemi.com = 3 ...
Page 6
... Figure 17. Input IP3 Vs. Frequency (Major attenuation states, 50 Ω System) 1200 1600 2000 Product Specification 0.2 0 -0.2 -0.4 -0.6 -0 Attenuati on Setting (dB 400 800 1200 RF Frequency (MHz) Document No. 70-0066-04 │ UltraCMOS™ RFIC Solutions PE4304 1200MHz, -40C 1200MHz, 25C 1200MHz, 85C 1600 2000 ...
Page 7
... PE4304 Product Specification Programming Options Parallel/Serial Selection Either a parallel or serial interface can be used to control the PE4304. The P/S bit provides this selection, with P/S=LOW selecting the parallel interface and P/S=HIGH selecting the serial interface. Parallel Mode Interface The parallel interface consists of five CMOS- compatible control lines that select the desired attenuation state, as shown in Table 5 ...
Page 8
... C, unless otherwise specified A Parameter Min LE minimum pulse width 10 LEPW Data set-up time before 10 PDSUP rising edge of LE Data hold time after 10 PDHLD falling edge of LE Document No. 70-0066-04 │ UltraCMOS™ RFIC Solutions PE4304 Product Specification B0 C0.5 ↑ LSB (last in) Max Unit ...
Page 9
... PE4304 Product Specification Figure 20. Package Drawing 0.435 0.18 DETAIL A 1. Dimension applies to metallized terminal and is measured between 0.25 and 0.30 from terminal tip. 2. Coplanarity applies to the exposed heat sink slug as well as the terminals. 3. Dimensions are in millimeters. Document No. 70-0066-04 │ www.psemi.com 4.00 2 ...
Page 10
... Figure 21. Marking Specifications Figure 22. Tape and Reel Drawing Table 10. Ordering Information Order Code Part Marking 4304-01 4304 4304-02 4304 4304-00 PE4304-EK 4304-51 4304 4304-52 4304 ©2003-2006 Peregrine Semiconductor Corp. All rights reserved. Page 4304 YYWW ZZZZZ YYWW = Date Code ZZZZZ = Last five digits of PSC Lot Number ...
Page 11
... PE4304 Product Specification Sales Offices The Americas Peregrine Semiconductor Corporation 9450 Carroll Park Drive San Diego, CA 92121 Tel: 858-731-9400 Fax: 858-731-9499 Europe Peregrine Semiconductor Europe Bâtiment Maine 13-15 rue des Quatre Vents F-92380 Garches, France Tel: +33-1-4741-9173 Fax : +33-1-4741-9173 Space and Defense Products ...