DS1306EN+ Maxim Integrated Products, DS1306EN+ Datasheet - Page 8

• Manufacturer Part Number: DS1306EN+
• Description: IC RTC SERIAL ALARM IND 20-TSSOP
• Manufacturer: Maxim Integrated Products
• Type: Clock/Calendar/Alarmr

Specifications of DS1306EN+

• Memory Size: 96B
• Time Format: HH:MM:SS (12/24 hr)
• Date Format: YY-MM-DD-dd
• Interface: SPI, 3-Wire Serial
• Voltage - Supply: 2 V ~ 5.5 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 20-TSSOP
• Function: Clock/Calendar/Alarm
• Rtc Memory Size: 96 Byte
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 2 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Rtc Bus Interface: Serial (3-Wire, SPI)
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

STATUS REGISTER (READ 10H)
IRQF0 (Interrupt 0 Request Flag) – A logic 1 in the interrupt request flag bit indicates that the current
time has matched the Alarm 0 registers. If the AIE0 bit is also a logic 1, the
cleared when the address pointer goes to any of the Alarm 0 registers during a read or write. IRQF0 is
activated when the device is powered by V
IRQF1 (Interrupt 1 Request Flag) – A logic 1 in the interrupt request flag bit indicates that the current
time has matched the Alarm 1 registers. If the AIE1 bit is also a logic 1, the INT1 pin generates a 62.5ms
active-high pulse. IRQF1 is cleared when the address pointer goes to any of the alarm 1 registers during a
read or write. IRQF1 is activated only when the device is powered by V
TRICKLE CHARGE REGISTER (READ 11H, WRITE 91H)
This register controls the trickle charge characteristics of the DS1306. The simplified schematic of Figure
3 shows the basic components of the trickle charger. The trickle charge select (TCS) bits (bits 4–7)
control the selection of the trickle charger. In order to prevent accidental enabling, only a pattern of 1010
enables the trickle charger. All other patterns disable the trickle charger. The DS1306 powers up with the
trickle charger disabled. The diode select (DS) bits (bits 2–3) select whether one diode or two diodes are
connected between V
diodes are connected between V
connected between V
in Table 3.
Figure 3. PROGRAMMABLE TRICKLE CHARGER
BIT7
0
BIT6
0
CC1
CC1
and V
and V
BIT5
CC2
CC2
0
CC1
. The diode select (DS) bits (bits 2–3) select whether one diode or two
. The resistor and diodes are selected by the RS and DS bits as shown
and V
CC1
BIT4
CC2
0
, V
. The resistor select (RS) bits select the resistor that is
CC2
8 of 22
, or V
BIT3
BAT
0
.
BIT2
CC2
0
or V
INT0
BAT
pin goes low. IRQF0 is
IRQF1
.
BIT1
IRQF0
BIT0