|
|
|
|
|
|
1.
1.1.
1.2.
1.3.
2.
2.1.
2.2.
3.
3.1.
©2008 Tyco Electronics Corporation
Harrisburg, PA
All International Rights Reserved.
SCOPE
Content
This specification covers perform ance, tests and quality requirem ents for AMPOW ER* quick disconnect
term inals designed to term inate 1/0 - 2/0 stranded copper conductor and facilitate quick
connect/disconnect capabilities for traction m otor leads on rapid transit vehicles.
Qualification
W hen tests are perform ed on the subject product line, procedures specified in Figure 1 shall be used.
All inspections shall be perform ed using the applicable inspection plan and product drawing.
Qualification Test Results
Successful qualification testing on the subject product line was com pleted on 26Aug98. The
Qualification Test Report num ber for this testing is 501-395-4. This docum entation is on file at and
available from Engineering Practices and Standards (EPS).
APPLICABLE DOCUM ENTS
The following docum ents form a part of this specification to the extent specified herein. Unless
otherwise specified, the latest edition of the docum ent applies. In the event of conflict between the
requirem ents of this specification and the product drawing, the product drawing shall take precedence.
In the event of conflict between the requirem ents of this specification and the referenced docum ents,
this specification shall take precedence.
Tyco Electronics Docum ents
!
!
!
!
!
!
!
Com m ercial Standard
UL486A: W ire Connectors and Soldering Lugs for Use W ith Copper Conductors
REQUIREM ENTS
Design and Construction
Product shall be of design, construction and physical dim ensions specified on the applicable product
drawing.
109-1: General Requirem ents for Test Specifications
109 Series: Test Specifications as indicated in Figure 1
108-30200: Product Specification (AMPPOW ER* Term inals & Splices, Sm all)
108-30200-1: Product Specification (AMPOW ER* Term inals & Splices, Medium )
108-30200-2: Product Specification (AMPOW ER* Term inals & Splices, Large)
114-2150: Application Specification (AMPOW ER* Term inals and Splices)
501-395-4: Qualification Test Report (AMPOW ER* Quick Disconnect Term inals)
* Trademark
| Indicates change
Product
Specification
AMPOWER* Quick Disconnect Terminals
For latest revision, visit our website at www.tycoelectronics.com\documents.
For Regional Customer Service, visit our website at www.tycoelectronics.com
108-30200-4
09Oct08 Rev B
1 of 4
LOC B