MCP4552T-503E/MF Microchip Technology, MCP4552T-503E/MF Datasheet - Page 55

• Manufacturer Part Number: MCP4552T-503E/MF
• Description: IC DGTL POT 50K 256TAPS 8-DFN
• Manufacturer: Microchip Technology

Specifications of MCP4552T-503E/MF

• Package / Case: 8-DFN
• Taps: 257
• Resistance (ohms): 50K
• Number Of Circuits: 1
• Temperature Coefficient: 150 ppm/°C Typical
• Memory Type: Volatile
• Interface: I²C, 2-Wire Serial
• Voltage - Supply: 1.8 V ~ 5.5 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Resistance In Ohms: 50K
• Number Of Pots: Single
• Taps Per Pot: 256
• Resistance: 50 KOhms
• Wiper Memory: Volatile
• Digital Interface: Serial (2-Wire, I2C)
• Operating Supply Voltage: 2.5 V, 3.3 V, 5 V
• Supply Current: 2.5 uA
• Maximum Operating Temperature: + 125 C
• Minimum Operating Temperature: - 40 C
• Mounting Style: SMD/SMT
• Supply Voltage (max): 5.5 V
• Supply Voltage (min): 1.8 V
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant
• Other names: MCP4552T-503E/MFTR

7.2
Only the Read Command and the Write Command
have Data Byte(s).
The Write command concatenates the 8-bits of the
Data Byte with the one data bit (D8) contained in the
Command Byte to form 9-bits of data (D8:D0). The
Command Byte format supports up to 9-bits of data so
that the 8-bit resistor network can be set to Full-Scale
(100h or greater). This allows wiper connections to
Terminal A and to Terminal B. The D9 bit is currently
unused.
TABLE 7-3:
© 2008 Microchip Technology Inc.
Write Data
Read Data
Increment Wiper
Decrement Wiper
High Voltage
High Voltage
High Voltage
High Voltage
Data Byte
Write Data
Read Data
Increment Wiper
Decrement Wiper
COMMANDS
Command Name
MCP453X/455X/463X/465X
7.3
If the four address bits received (AD3:AD0) and the two
command bits received (C1:C0) are a valid combina-
tion, the MCP4XXX will Acknowledge the I
If the address bits and command bits are an invalid
combination, then the MCP4XXX will Not Acknowledge
the I
Once an error condition has occurred, any following
commands are ignored until the I
Start Condition.
7.3.1
A Restart or Stop condition in the expected data bit
position will abort the current command sequence and
2
C bus.
Error Condition
ABORTING A TRANSMISSION
# of Bits
2
29
29
20
20
29
29
20
20
C bus is reset with a
DS22096A-page 55
2
HVC pin?
C bus.
(V
Voltage
High
IHH
Yes
Yes
Yes
Yes
—
—
—
—
) on