DS1869-100 Maxim Integrated Products, DS1869-100 Datasheet - Page 8

• Manufacturer Part Number: DS1869-100
• Description: IC RHEOSTAT DALLAST 3V 100K 8DIP
• Manufacturer: Maxim Integrated Products
• Series: Dallastat™r

Specifications of DS1869-100

• Taps: 64
• Resistance (ohms): 100K
• Number Of Circuits: 1
• Temperature Coefficient: 750 ppm/°C Typical
• Memory Type: Non-Volatile
• Interface: Contact Closure
• Voltage - Supply: ± 2.7 V ~ 8 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Through Hole
• Package / Case: 8-DIP (0.300", 7.62mm)
• Resistance In Ohms: 100K
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

TIMING DIAGRAMS Figure 5
NOTES:
1. All inputs; UC, DC, and D are internally pulled up with a typical resistance of 100 k .
2. Input logic levels are referenced to -V.
3. I
4. Input leakage applies to contact inputs UC and DC and the digital input (D).
5. Wiper current is the maximum current which can flow through the wipers.
6. Capacitance values apply at 25 C.
7. Input pulse width is the minimum time required for an input to cause an increment or decrement. If
8. Repetitive pulsed inputs on UC, DC, or D will be recognized as long as the pulse repetition occurs
9. Idle state supply current is measured with no pushbutton pressed and with the wiper R
10. For +V referenced to -V = 5V.
11. Valid at 25 C only.
the UC, DC, or D input is held active for longer than 1 second, subsequent increments or decrements
will occur on 100 ms intervals until the inputs UC, DC, and/or D is released to V
within 1 second of each other. Pulses occurring faster than 1 ms apart may not be recognized as
individual inputs but can be interpreted a constant input. Tolerance for pulse timing is 15% on
minimum inputs.
CMOS load.
CC
is the internal current that flows between -V and +V.
8 of 8
t
CPW
IH
.
W
tied to a
DS1869