1274566-1 TE Connectivity, 1274566-1 Datasheet - Page 5

• Manufacturer Part Number: 1274566-1
• Description: RF/COAXIAL, BNC PLUG, R/A, 75OHM, CRIMP
• Manufacturer: TE Connectivity

Specifications of 1274566-1

• Connector Type: BNC Coaxial
• Body Style: Right Angle Plug
• Coaxial Termination: Crimp
• Impedance: 75ohm
• Rg Cable Type: AT&T 735A
• Contact Material: Brass
• Contact Plating: Gold
• Frequency Max: 2GHz
• Rohs Compliant: Yes
• Product Type: Connector Kit
• Gender: Plug
• Stacked: No
• Crimp Type: Hex
• Grade: Commercial
• Body Material: Brass
• Sealed: No
• Isolated: No
• Dielectric Material: PTFE
• Coupling Nut Material: Brass
• Number Of Ports: 1
• Panel Mount Retention: Without
• Connector Impedance (?): 75
• Insulation Resistance (m?): 1,000
• Frequency: DC - 2 GHz
• Coaxial Cable Termination Type: Crimp
• Hardware Included: Yes
• Body Plating: Nickel
• Polarized: No
• Center Contact Material: Brass
• Center Contact Plating: Gold
• Connector Style: Plug
• Coaxial Cable Type (rg/u Or Mfg.): 735A
• Government/industry Qualification: No
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Not relevant for lead free process
• Rohs/elv Compliance History: Always was RoHS compliant
• Applies To: Coaxial Cable
• For Use With: Mini BNC Connector

4.
4.1.
4.2.
4.3.
4.4.
Rev C
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form , fit or function are m ade to the product or m anufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determ ined by developm ent/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product m eets the requirem ents of Figure 1. Failures
attributed to equipm ent, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specim ens resubm itted for qualification. Testing to
confirm corrective action is required before resubm ittal.
Quality Conform ance Inspection
The applicable quality inspection plan shall specify the sam pling acceptable quality level to be used.
Dim ensional and functional requirem ents shall be in accordance with the applicable product drawing
and this specification.
Specim en Selection
Specim ens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of a m inim um of 5
specim ens.
Test Sequence
Qualification inspection shall be verified by testing specim ens as specified in Figure 2.
Low Level Contact Resistance Measurem ent Points
Figure 3
108-2159
5 of 5