AMSRL-7815-NZ Aimtec Inc., AMSRL-7815-NZ Datasheet - Page 3

• Manufacturer Part Number: AMSRL-7815-NZ
• Description: DC/DC SWITCHING REGULATOR
• Manufacturer: Aimtec Inc.

It is recommended that ceramic capacitors are used for C2 & C3.
It is recommended to install C3 to improve performance.
C1 & C2 are required and should be installed as close to the converter as possible
If it is needed to adjust the output voltage higher or lower than the converter’s nominal value use the equations in the table
above to calculate appropriate resistor values, insuring that the voltage is within the adjustment range for the converter used.
If no voltage adjustment is needed connect a 470uF ceramic capacitor from pin 6 to ground.
Application Circuit
Model Number
AMSRL-783.3-NZ
AMSRL-7805-NZ
AMSRL-7812-NZ
AMSRL-7815-NZ
Model Number
NOTE: 1.
by Aimtec; refer to www.aimtec.com for the most current product specifications.
date manufactured.
nominal input voltage and at rated output load unless otherwise specified.5..Aimtec may not have conducted destructive testing or chemical analysis on all internal components
and chemicals at the time of publishing this document. CAS numbers and other limited information are considered proprietary and may not be available for release.
product is not designed for use in critical life support systems, equipment used in hazardous environments, nuclear control systems or other such applications which necessitate
specific safety and regulatory standards other the ones listed in this datasheet.
www.aimtec.com
F 051e R8.B
AMSRL-783.3-NZ
AMSRL-7805-NZ
AMSRL-7812-NZ
AMSRL-7815-NZ
V Input
10uF
50V
Ground
Datasheets are updated as needed and as such, specifications are subject to change without notice. Once printed or downloaded, datasheets are no longer controlled
C1
1
3.
ON/OFF
Mechanical drawings and specifications are for reference only.
AMSRL-78XX-NZ
Output (V)
Nominal
10
C2 (uF)
3.3
12
15
5
22
22
10
10
7&9
6
470 uf
C5
Vout Adjusted Up
5
R2 (KΩ)
R1
R2
Tel: [phone]
2.
Product labels shown, including safety agency certifications on labels, may vary based on the
C2
3 of 3
V Output
4.
Ground
All specifications are measured at an ambient temperature of 25°C, humidity<75%,
100uF
C3
Vout Adjusted Down
20V
R1 (KΩ)
Up to 7.5 Watt | DC-DC Converter
Series AMSRL-78-NZ
Toll free: + 1 888 9 AIMTEC
North America only
5.
(924 6832)
This