12-215/W1D-ANPHY/3C Everlight Electronics CO., LTD, 12-215/W1D-ANPHY/3C Datasheet - Page 9

• Manufacturer Part Number: 12-215/W1D-ANPHY/3C
• Manufacturer: Everlight Electronics CO., LTD

4.Soldering Iron
within once in less than the soldering iron capacity 25W. Leave two seconds and more intervals, and do
soldering of each terminal. Be careful because the damage of the product is often started at the time of the
hand solder.
5.Repairing
double-head soldering iron should be used (as below figure). It should be confirmed beforehand whether
the characteristics of the LEDs will or will not be damaged by repairing.
EVERLIGHT ELECTRONICS CO., LTD.
Office: No 25, Lane 76, Sec 3, Chung Yang Rd,
Everlight Electronics Co., Ltd.
Device No:SZDSE-125-007
Tucheng, Taipei 236, Taiwan, R.O.C
Repair should not be done after the LEDs have been soldered. When repairing is unavoidable, a
Each terminal is to go to the tip of soldering iron temperature less than 350℃ for 3 seconds
EVERLIGHT ELECTRONICS CO.,LTD.
http://www.everlight.com
Prepared date:19-Aug-2005
Fax: [phone]
Tel: [phone]
http://www.everlight.com
12-215UYC/S530-XX/TR8
Rev 1
Prepared by:Meng Yali
Page: 9 of 9