20-101-1139 Rabbit Semiconductor, 20-101-1139 Datasheet - Page 23

• Manufacturer Part Number: 20-101-1139
• Description: RCM4310 RABBITCORE
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1139

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Data Bus Width: 8 bit
• Core Processor: Rabbit 4000
• Clock Speed: 58.98 MHz
• Interface Type: Ethernet
• Flash: 1 MByte
• Timers: 10 x 8 bit
• Operating Supply Voltage: 3.3 V
• Board Size: 72 mm x 47 mm x 21 mm
• For Use With/related Products: RCM4310
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1142

•
RabbitCore RCM4300 User’s Manual
IOCONFIG_SWITCHECHO.C
which then transmits and then receives an ASCII string when switch S2 is pressed. The
echoed serial data are displayed in the Dynamic C
Note that the I/O lines that carry the Serial Port E signals are not the Rabbit 4000
defaults. The Serial Port E I/O lines are configured by calling the library function
serEconfig()
Serial Port E is configured to use Parallel Port E bits PD6 and PD7. These signals are
available on the Prototyping Board's Module Extension Header (header J2).
Serial Port D is left in its default configuration, using Parallel Port C bits PC0 and PC1.
These signals are available on the Prototyping Board's RS-232 connector (header J4).
Serial Port D transmits and then receives an ASCII string when switch S3 is pressed.
Also note that there is one library generated by
SAMPLES\RCM4300\SERIAL
To set up the Prototyping Board, you will need to tie TxD
and RxD together on the RS-232 header at J4 using the
jumpers supplied in the Development Kit; you will also
tie TxE (PD6) and RxE (PD7) together with a soldered
wire or with a wire jumper if you have soldered in the
IDC header supplied with the accessory parts in the
Development Kit.
Once you have compiled and run this program, press and
release switches S2 or S3 on the Prototyping Board. The data echoed between the serial
ports will be displayed in the
that was generated by the Rabbit 4000
—This program demonstrates how to set up Serial Port E,
STDIO
folder for the 29 MHz RCM4210.
window.
IOCONFIG.EXE
STDIO
IOCONFIG.EXE
window.
in the Dynamic C
utility program.
23