20-101-1051 Rabbit Semiconductor, 20-101-1051 Datasheet - Page 15

• Manufacturer Part Number: 20-101-1051
• Description: MODULE RABBITCORE RCM3365
• Manufacturer: Rabbit Semiconductor

Specifications of 20-101-1051

• Module/board Type: MPU Core Module
• Product: Microcontroller Modules
• Core Processor: Rabbit 3000
• Flash: 512 KBytes
• Operating Supply Voltage: 3.15 to 3.45 V
• Board Size: 69 mm x 47 mm x 22 mm
• For Use With/related Products: RCM3365
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Other names: 316-1111

2.1 Install Dynamic C
To develop and debug programs for the RCM3365/RCM3375 (and for all other Rabbit
hardware), you must install and use Dynamic C.
If you have not yet installed Dynamic C version 9.24 (or a later version), do so now by
inserting the Dynamic C CD from the Development Kit in your PC’s CD-ROM drive. If
autorun is enabled, the CD installation will begin automatically.
If autorun is disabled or the installation otherwise does not start, use the Windows
Start | Run
of the CD-ROM.
The installation program will guide you through the installation process. Most steps of the
process are self-explanatory.
Dynamic C uses a COM (serial) port to communicate with the target development system.
The installation allows you to choose the COM port that will be used. The default selec-
tion is COM1. You may select any available port for Dynamic C’s use. If you are not cer-
tain which port is available, select COM1. This selection can be changed later within
Dynamic C.
Once your installation is complete, you will have up to three icons on your PC desktop.
One icon is for Dynamic C, one opens the documentation menu, and the third is for the
Rabbit Field Utility, a tool used to download precompiled software to a target system.
If you have purchased the optional Dynamic C Rabbit Embedded Security Pack, install it
after installing Dynamic C. You must install the Rabbit Embedded Security Pack in the
same directory where Dynamic C was installed.
User’s Manual
This chapter explains how to set up and use the RCM3365/
RCM3375 modules with the accompanying Prototyping Board.
NOTE: It is assumed that you have a Development Kit. If you purchased an RCM3365 or
NOTE: The installation utility does not check the selected COM port in any way. Speci-
RCM3375 module by itself, you will have to adapt the information in this chapter and
elsewhere to your test and development setup.
fying a port in use by another device (mouse, modem, etc.) may lead to a message such
as
menu or Windows Disk Explorer to launch
"could not open serial port"
2. G
when Dynamic C is started.
ETTING
setup.exe
from the root folder
S
TARTED
9