XW1E-BV411M-R IDEC Corporation, XW1E-BV411M-R Datasheet - Page 6

• Manufacturer Part Number: XW1E-BV411M-R
• Description: Switch, E-STOP, 22mm, 40MM MUSHROOM BUTTON, WITH SCREW TerminalS, 1NO-1NC
• Manufacturer: IDEC Corporation
• Type: Pushbuttonr

Specifications of XW1E-BV411M-R

• Actuator Type: Mushroom
• Contact Form: 1 NC/NO
• Current, Rating: 5/2 AAC/ADC
• Dielectric Strength: 250 V
• Electrical Life: 100000 (Min.) Operations
• Force, Operating: 32 N (Pushlock), 21 N (Pull Reset), 0.27 Nm (Turn Reset)
• Function: E-Stop
• Ip Rating: IP65
• Mechanical Life: 250000 (Min.) Operations
• Mounting Hole Size: 22.3 mm
• Mounting Type: Panel
• Number Of Poles: 1
• Operation: Push-Lock Turn-Reset
• Standards: cULus Listed, CE Marked, TUV Approved
• Temperature, Operating: -25 to +55 °C
• Termination: Screw
• Voltage, Rating: 250 VAC/VDC
• Two Button Sizes: 40 mm and 60 mm (XW Series)
• Lead Free Status / Rohs Status: RoHS Compliant part

Screw Terminal
1. Wire thickness: AWG18 to 16
2. Tighten the M3 terminal screw to a tightening torque of 0.6 to 1.0 N·m.
Installing and Removing Terminal Covers
XW9Z-VL2M
To install the terminal cover, align the TOP marking on the terminal cover with
the TOP marking on the contact block. Place the two projections on the bottom
side of the contact block into the slots in the terminal cover. Press the terminal
cover toward the contact block.
To remove the terminal cover, pull out the two latches on the top side of the
terminal cover. Do not exert excessive force to the latches, otherwise the latches
may break.
j Place the projections
on the contact block
XW Series
TOP Markings
TOP marking
Pull out the latches
k Press the
Operating Instructions, continued
terminal cover
IP20 Protection Terminal Cover
XW9Z-VL2MF
To install the IP20 protection cover, align the TOP marking on the cover with the
TOP marking on the contact block, and press the cover toward the contact block.
Contact Bounce
When the button is reset by pulling or turning, the NC main contacts will bounce.
When pressing the button, the NO monitor contacts will bounce.
When designing a control circuit, take the contact bounce time into consider-
ation (reference value: 20 ms).
LED Illuminated Switches
LED lamp is built into the contact block and cannot be replaced.
Installing the Anti-rotation Ring
HW9Z-RL
Align the side without thread on the operator with TOP marking, the small s
marking on the anti-rotation ring, and the recess on the mounting panel.
Anti-rotation Ring (HW9Z-RL)
1. Once installed, the XW9Z-VL2MF cannot be removed.
2. The XW9Z-VL2MF cannot be installed after wiring.
3. With the XW9Z-VL2MF installed, crimping terminals cannot be used.
4. Make sure that the XW9Z-VL2MF is securely installed. IP20 protection cannot be achieved
TOP marking
when installed loosely, and electric shocks may occur.
Without thread
p marking on the anti-rotation ring
(Press)
X Series E-Stops
TOP marking
TOP marking