RTB-G01 IDEC Corporation, RTB-G01 Datasheet - Page 3

• Manufacturer Part Number: RTB-G01
• Description: Relay; Panel Mount; All RTE timer; RTE Series
• Manufacturer: IDEC Corporation

Specifications of RTB-G01

• Brand/series: RTE Series
• Mounting Type: Panel Mount
• Lead Free Status / Rohs Status: RoHS Compliant part
• For Use With: All RTE timer

Special expertise is required to use Electronic Timers.
• All Electronic Timers are manufactured under IDEC's rigorous qual-
• Install the Electronic Timer according to instructions described in
• Make sure that the operating conditions are as described in the spec-
• In these directions, safety precautions are categorized in order of
Warnings
Warning notices are used to emphasize that improper operation may
cause severe personal injury or death.
• Turn power off to the Electronic timer before starting installation,
• Failure to turn power off may cause electrical shocks or fire hazard.
• Do not use the Electronic Timer for an emergency stop circuit or
Types
www.idec.com
ity control system, but users must add a backup or fail safe provision
to the control system when using the Electronic Timer in applica-
tions where heavy damage or personal injury may occur should the
Electronic Timer fail.
this catalog.
ifications. If you are uncertain about the specifications, contact
IDEC in advance.
importance under Warning and Caution.
removal, wiring, maintenance, and inspection on the Electronic
Timer.
interlocking circuit. If the Electronic Timer should fail, a machine
malfunction, breakdown, or accident may occur.
R T E - P 1 A F 2 0
Connection type
P: Pin
B: Blade
Timers
Operation Mode
1: No Control Signal
A: ON-Delay 1
B: Interval
C: Cycle 1
D: Cycle 3
Mounting A
Power Voltage
AF20: 100 to 240V AC(50/60Hz)
AD24: 24V AC(50/60Hz)/24V DC
D12: 12V DC
2: Control Signal
A: ON-Delay 2
B: Cycle 2
C: Cycle 4
D: Signal ON/OFF-Delay
E: Signal OFF-Delay
F: One-Shot
USA: (800) 262-IDEC or [phone], Canada (888) 317-IDEC
10A
7A
Ambient Temperature
Mounting A
Derating Curve
Temperature Derating Curves
50ºC 65ºC
Safety Precautions
Instructions
Caution
Caution notices are used where inattention might cause personal
injury or damage to equipment.
• The Electronic Timer is designed for installation in equipment. Do
• Install the Electronic Timer in environments described in the specifi-
• Use an IEC60127-approved fuse and circuit breaker on the power
• Do not disassemble, repair, or modify the Electronic Timer.
• When disposing of the Electronic Timer, do so as industrial waste.
Switch Settings
not install the Electronic Timer outside equipment.
cations. If the Electronic Timer is used in places where it will be
subjected to high-temperature, high-humidity, condensation, corro-
sive gases, excessive vibrations, or excessive shocks, then electrical
shocks, fire hazard, or malfunction could result.
and output line outside the Electronic Timer.
1
Mounting B
1
2
3
Operation Mode
Selector
Scale Selector
Time Range
Selector
3
2
1. Turn the selectors securely using a flat
2. Since changing the setting during timer
screwdriver 4mm wide (maximum).
Note that incorrect setting may cause
malfunction. Do not turn the selectors
beyond their limits.
operation may cause malfunction, turn
power off before changing.
7A
5A
Ambient Temperature
Mounting B
Derating Curve
50ºC 65ºC
RTE Series
G-13
G