PIC32MX320F064HT-80V/MR Microchip Technology, PIC32MX320F064HT-80V/MR Datasheet - Page 34

• Manufacturer Part Number: PIC32MX320F064HT-80V/MR
• Description: 64 KB Flash, 16 KB RAM, 80 MHz, 10-Bit ADC, DMA 64 QFN 9x9x0.9mm T/R
• Manufacturer: Microchip Technology
• Series: PIC® 32MXr

Specifications of PIC32MX320F064HT-80V/MR

• Core Processor: MIPS32® M4K™
• Core Size: 32-Bit
• Speed: 80MHz
• Connectivity: I²C, IrDA, LIN, PMP, SPI, UART/USART
• Peripherals: Brown-out Detect/Reset, POR, PWM, WDT
• Number Of I /o: 53
• Program Memory Size: 64KB (64K x 8)
• Program Memory Type: FLASH
• Eeprom Size: -
• Ram Size: 16K x 8
• Voltage - Supply (vcc/vdd): 2.3 V ~ 3.6 V
• Data Converters: A/D 16x10b
• Oscillator Type: Internal
• Operating Temperature: -40°C ~ 105°C
• Package / Case: 64-VFQFN Exposed Pad
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

PIC32MX3XX/4XX
2.9
If MPLAB ICD 2, ICD 3 or REAL ICE is selected as a
debugger, it automatically initializes all of the Analog-
to-Digital input pins (ANx) as “digital” pins by setting all
bits in the ADPCFG register.
The bits in this register that correspond to the Analog-
to-Digital pins that are initialized by MPLAB ICD 2, ICD
3 or REAL ICE, must not be cleared by the user
application firmware; otherwise, communication errors
will result between the debugger and the device.
If your application needs to use certain Analog-to-
Digital pins as analog input pins during the debug
session,
corresponding bits in the ADPCFG register during
initialization of the ADC module.
When MPLAB ICD 2, ICD 3 or REAL ICE is used as a
programmer, the user application firmware must
correctly configure the ADPCFG register. Automatic
initialization of this register is only done during
debugger operation. Failure to correctly configure the
register(s) will result in all Analog-to-Digital pins being
recognized as analog input pins, resulting in the port
value being read as a logic ‘0’, which may affect user
application functionality.
DS61143H-page 34
Configuration of Analog and
Digital Pins During ICSP
Operations
the
user
application
must
clear
the
2.10
Unused I/O pins should not be allowed to float as
inputs. They can be configured as outputs and driven
to a logic-low state.
Alternately, inputs can be reserved by connecting the
pin to V
the pin as an input.
SS
Unused I/Os
through a 1k to 10k resistor and configuring
© 2011 Microchip Technology Inc.