5406436-1 TE Connectivity, 5406436-1 Datasheet - Page 6

• Manufacturer Part Number: 5406436-1
• Manufacturer: TE Connectivity

Specifications of 5406436-1

• Product Type: Connector
• Jack Type: RJ45
• Pcb Mounting Orientation: Top Entry (Vertical)
• Pcb Mount Style: Through Hole
• Termination Method To Pc Board: Solder
• Performance Category: Cat 3
• Number Of Contacts Loaded: 8
• Grounding Options: Panel Ground and PCB Ground
• Panel Stops: With
• Keyed: No
• Profile: Standard
• Color: Black
• Shield Material: Copper Alloy
• Latch Style: Standard
• Jack Configuration: 1 x 1
• Panel Mount Retention: With
• Flanged: No
• Shielded: Yes
• Solder Tail Contact Plating: Tin over Nickel
• Height (mm [in]): 16.64 [0.655]
• Port Configuration: Single
• Number Of Positions: 8
• Inverted Jack Face: No
• Led: Without
• Shield Plating: Tin
• Number Of Pcb Ground Tabs: 2
• Pcb Tail Length (mm [in]): 3.18 [0.125]
• Pcb Ground Tab Location (mm [in]): 2.95 [0.116]
• Preloaded: Yes
• Contact Plating, Mating Area, Material: Gold (50)
• Contact Base Material: Phosphor Bronze
• Housing Material: PBT - GF
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Always was RoHS compliant
• Pcb Thickness, Recommended (mm [in]): 1.57 [0.062]
• Packaging Method: Tray

4.
4.1.
4.2.
4.3.
4.4.
Rev G
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit, or function are made to the product or to the manufacturing
process, product assurance shall coordinate requalification testing, consisting of all or part of the
original testing sequence as determined by development/product, quality, and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup, or operator deficiencies shall not disqualify the product. When
product failure occurs, corrective action shall be taken and samples resubmitted for qualification.
Testing to confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan will specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Sample Selection
Modular plug and jack test samples shall be selected at random from current production lots. They
shall be prepared for testing in accordance with current Application Specifications and Instruction
Sheets.
Test Sequence
Qualification testing shall be conducted as specified in Figure 2.
108-1163
6 of 7