4307-0 Peregrine Semiconductor, 4307-0 Datasheet
4307-0
Specifications of 4307-0
Related parts for 4307-0
4307-0 Summary of contents
Page 1
... Product Description The PE4307 is a high linearity, 5-bit RF Digital Step Attenuator (DSA) covering a 15.5 dB attenuation range in 0.5 dB steps. The device is pin compatible with the PE430x series. This 75- ohm RF DSA provides both parallel (latched or direct mode) and serial CMOS control interface, operates on a single 3-volt supply and maintains high attenuation accuracy over frequency and temperature ...
Page 2
... Table 3. Latch-Up Avoidance Unlike conventional CMOS devices, UltraCMOS™ devices are immune to latch-up. Switching Frequency or DC blocked with an The PE4307 has a maximum 25 kHz switching rate. DC DD. Resistor on Pin 3 (-VDD) to bypass and A 10 kΩ resistor on the input to Pin 3 (see Figure 5) will eliminate package resonance between the RF input pin and the digital input ...
Page 3
... PE4307 Product Specification Evaluation Kit The Digital Attenuator Evaluation Kit was designed to ease customer evaluation of the PE4307 DSA used in conjunction with the supplied DC cable to supply V , GND, and – use of the internal DD DD negative voltage generator is desired, then connect – V (black banana plug) to ground external – desired, then apply -3V ...
Page 4
... Figure 9. Output Return Loss at Major 4dB 1500 2000 Product Specification 1dB 6 0.5dB 500 1000 RF Frequency (MHz) Attenuation Steps (Zo=75 ohms) 0 -10 -20 -30 -40 -50 0 500 1000 RF Frequency (MHz) Document No. 70-0161-04 │ UltraCMOS™ RFIC Solutions PE4307 15.5dB 8dB 4dB 2dB 1500 2000 1500 2000 ...
Page 5
... PE4307 Product Specification Typical Performance Data @ 25°C, V Figure 10. Attenuation Error Vs. Frequency 0.5 0 -0 500 1000 RF Frequency (MHz) Figure 12. Input IP3 vs. Frequency (Zo=50 ohms 500 1000 RF Frequency (MHz) Note: Positive attenuation error indicates higher attenuation than target value Document No. 70-0161-04 │ www.psemi.com = 3 ...
Page 6
... Product Specification Setting 0.4 0.3 0.2 0.1 0 -0.1 500MHz, -40C -0.2 500MHz, 25C -0.3 500MHz, 85C -0 Attenuation Setting (dB) Setting 0.4 0.3 0.2 0.1 0 -0.1 -0.2 -0.3 1200MHz, 85C -0 Attenuation Setting (dB) Document No. 70-0161-04 │ UltraCMOS™ RFIC Solutions PE4307 1200MHz, -40C 1200MHz, 25C ...
Page 7
... Note: Not all 32 possible combinations of C0.5-C8 are shown in table Serial Interface The PE4307’s serial interface is a 6-bit serial-in, parallel-out shift register buffered by a transparent latch. The latch is controlled by three CMOS- compatible signals: Data, Clock, and Latch Enable (LE). The Data and Clock inputs allow data to be Document No. 70-0161-04 │ ...
Page 8
... C, unless otherwise specified A Parameter Min LE minimum pulse width 10 LEPW Data set-up time before 10 PDSUP rising edge of LE Data hold time after 10 PDHLD falling edge of LE Document No. 70-0161-04 │ UltraCMOS™ RFIC Solutions PE4307 Product Specification C0.5 ↑ LSB (last in Max Unit -- ...
Page 9
... PE4307 Product Specification Figure 20. Package Drawing 20 Lead 4x4 mm QFN 0.435 0.18 DETAIL A 1. Dimension applies to metallized terminal and is measured between 0.25 and 0.30 from terminal tip. 2. Coplanarity applies to the exposed heat sink slug as well as the terminals. 3. Dimensions are in millimeters. Document No. 70-0161-04 │ www.psemi.com 4 ...
Page 10
... Figure 21. Marking Specifications Figure 22. Tape and Reel Drawing Table 10. Ordering Information Order Code Part Marking 4307-01 4307 4307-02 4307 4307-00 PE4307-EK 4307-51 4307 4307-52 4307 ©2003-2006 Peregrine Semiconductor Corp. All rights reserved. Page 4307 YYWW ZZZZZ YYWW = Date Code ZZZZZ = Last five digits of PSC Lot Number ...
Page 11
... PE4307 Product Specification Sales Offices The Americas Peregrine Semiconductor Corporation 9450 Carroll Park Drive San Diego, CA 92121 Tel: 858-731-9400 Fax: 858-731-9499 Europe Peregrine Semiconductor Europe Bâtiment Maine 13-15 rue des Quatre Vents F-92380 Garches, France Tel: +33-1-4741-9173 Fax : +33-1-4741-9173 Space and Defense Products ...