RN-XV Roving Networks Inc, RN-XV Datasheet
RN-XV
Specifications of RN-XV
RN-XV-W
RN-XVEE
XVEE
Related parts for RN-XV
RN-XV Summary of contents
Page 1
... Robotics • 809 University Avenue RN-XV Data Sheet (Preliminary) Description The RN- 802.11 b/g solution especially designed for customer who want to migrate their existing 802.15.4 architecture to a more standard TCP/IP based platform without having to redesign their existing hardware. Based on a pseudo standard footprint often found in ...
Page 2
... Standby (doze) Connected (idle, RX) Connected (TX) Analog Sensor Inputs Parameter Sense 0,1,2,3 wakeup detect threshold AD sense 0-4 measurement range Precision Accuracy Minimum conversion time Sensor Power (pin 33) output resistance 3.3V • 809 University Avenue RN-XV Data Sheet (Preliminary) Value 90% 90% Min Typ ...
Page 3
... Measured at 3.3VDC input. The power consumption is the average power, active during actual power consumption • 809 University Avenue RN-XV Data Sheet (Preliminary) 802.11b compatibility : DSSS(CCK-11, CCK-5.5, DQPSK-2, DBPSK-1) 802.11g : OFDM (default) 1 – 11Mbps for 802.11b / 6 – 54Mbps for 802.11g 0dBm to +12dBm (software configurable) 802 ...
Page 4
... GPIO 3/SEN 4 19 GPIO 2/SEN 3 20 GPIO 1/SEN 2 • 809 University Avenue RN-XV Data Sheet (Preliminary) 1 mil = 0.0254 millimeters Description 3.3V regulated power input to the module UART TX, 8mA drive, 3.3V tolerant UART RX, 3.3V tolerant GPIO, 24mA drive, 3.3V tolerant Optional Module Reset Signal (active low), 100k Pull up, apply pulse of at least 160us, 3 ...
Page 5
... Module Schematic • 809 University Avenue RN-XV Data Sheet (Preliminary) Pins 13, 15, 18, 19 and 20 on the RN-XV connector can be configured as GPIOs or as sensor inputs depending on the installed resistors. When configured as GPIOs, ONLY Column 1 resistors MUST be installed. When configured as sensor inputs, ONLY Column 2 and Column 3 resistors MUST be stuffed ...
Page 6
... Design Concerns 1. Powering the RN-XV module: Apply ONLY 3.3V±10% regulated power to pin 1 (VDD) and pin 10 (Ground). The module does not have any voltage regulator on board and hence MUST be powered from a regulated 3.3V power supply. 2. Antenna: The RN-XV ships with a wire antenna. Custom antenna configurations such as chip, U.FL. and ...