ADG708BRU Analog Devices Inc, ADG708BRU Datasheet - Page 19

• Manufacturer Part Number: ADG708BRU
• Description: IC MULTIPLEXER 8X1 16TSSOP
• Manufacturer: Analog Devices Inc
• Type: Analog Multiplexerr

Specifications of ADG708BRU

• Rohs Status: RoHS non-compliant
• Function: Multiplexer
• Circuit: 1 x 8:1
• On-state Resistance: 4.5 Ohm
• Voltage Supply Source: Single, Dual Supply
• Voltage - Supply, Single/dual (±): 1.8 V ~ 5.5 V, ±2.5 V
• Current - Supply: 0.001µA
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-TSSOP (0.173", 4.40mm Width)
• No. Of Channels: 8
• Analog Switch Case Style: TSSOP
• No. Of Pins: 16
• Single Supply Voltage Min (+v): 1.8V
• Analog Multiplexer Type: Single 8 X 1
• Peak Reflow Compatible (260 C): No
• Leakage Current: 0.01nA
• Multiplexer Configuration: Single 8:1
• Number Of Inputs: 8
• Number Of Outputs: 1
• Number Of Channels: 1
• Analog Switch On Resistance: 11@3VOhm
• Analog Switch Turn On Time: 18ns
• Analog Switch Turn Off Time: 8ns
• Package Type: TSSOP
• Power Supply Requirement: Single/Dual
• Single Supply Voltage (min): 1.8V
• Single Supply Voltage (typ): 3/5V
• Single Supply Voltage (max): 5.5V
• Dual Supply Voltage (typ): ±2.5V
• Power Dissipation: 432mW
• Supply Current: 0.001mA
• Mounting: Surface Mount
• Pin Count: 16
• Operating Temp Range: -40C to 85C
• Operating Temperature Classification: Industrial
• Package: 16TSSOP
• Maximum On Resistance: 11@3V Ohm
• Maximum Propagation Delay Bus To Bus: 14(Typ)@5V|18(Typ)@3V|14(Typ)@±2.5V ns
• Maximum High Level Output Current: 30 mA
• Multiplexer Architecture: 8:1
• Maximum Turn-off Time: 8(Typ)@3V ns
• Maximum Turn-on Time: 18(Typ)@3V ns
• Power Supply Type: Single|Dual
• Lead Free Status / Rohs Status: Not Compliant

ADG708/ADG709
APPLICATIONS INFORMATION
POWER SUPPLY SEQUENCING
When using CMOS devices, take care to ensure correct power
supply sequencing. Incorrect power supply sequencing can
result in the device being subjected to stresses beyond the
maximum ratings listed in Figure 4.
Always apply digital and analog inputs after power supplies and
ground. For single-supply operation, tie V
to GND as close to
SS
the device as possible.
Rev. C | Page 19 of 20