CT2-ML2LACW51A1 JDS UNIPHASE, CT2-ML2LACW51A1 Datasheet - Page 6

• Manufacturer Part Number: CT2-ML2LACW51A1
• Manufacturer: JDS UNIPHASE

Specifications of CT2-ML2LACW51A1

• Number Of Transmitters: 1
• Power Supply Requirement: Single
• Operating Temperature Classification: Commercial
• Pin Count: 20
• Operating Temperature (max): 70C
• Operating Temperature (min): 0C
• Supply Current: 350mA
• Dual Supply Voltage (typ): Not RequiredV
• Dual Supply Voltage (max): Not RequiredV
• Dual Supply Voltage (min): Not RequiredV
• Lead Free Status / Rohs Status: Supplier Unconfirmed

6
Power Supply Voltage
Parameter
Supply voltage
Power supply current drain
1. Applies to hardware revision 2. Does not include output termination resistor current.
Timing of Status and Control Input/Output
Parameter
TX_DISABLE assert time
TX_DISABLE deassert time
Time to initialize
TX_FAULT assert time
TX_DISABLE for reset
LOS assert time
LOS deassert time
2-wire serial clock rate
1
t_off
t_on
t_init
t_fault
t_loss_on
t_loss_off
Symbol
t_reset
f_serial_clock
Typical
Maximum
Typical
Maximum
Minimum
Condition
Time from rising edge of TX_DISABLE to when the
output optical power falls below 10% of nominal
Time from falling edge of TX_DISABLE to when the
output optical power rises above 90% of nominal
Upon power up or negation of TX_FAULT due to TX_DISABLE
Time from a fault condition to TX_FAULT assertion
Time TX_DISABLE must be held HIGH to reset TX_FAULT
Time from loss of signal to assertion of LOS
Time from non-loss condition to LOS deassertion
-
Short Haul (40 km, PIN)
3.1 V
3.3 V
3.5 V
275 mA
320 mA
2.5 GB/S CWDM SFP TRANSCEIVER
Long Haul (80 km, APD)
3.1 V
3.3 V
3.5 V
285 mA
350 mA
Maximum 10 µs
Maximum 1 ms
Maximum 300 ms
Maximum 100 µs
Minimum 10 µs
Maximum 100 µs
Maximum 100 µs
Maximum 100 kHz
Specification