ISD4002-120SI Nuvoton Technology Corporation of America, ISD4002-120SI Datasheet - Page 7

• Manufacturer Part Number: ISD4002-120SI
• Description: IC VOICE REC/PL 120SEC IN 28SOIC
• Manufacturer: Nuvoton Technology Corporation of America
• Series: ISD4002r

Specifications of ISD4002-120SI

• Interface: SPI/Microwire
• Filter Pass Band: 3.4kHz
• Duration: 120 Sec
• Mounting Type: Surface Mount
• Package / Case: 28-SOIC (0.300", 7.50mm Width)
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: ISD4002120SI

6. PIN DESCRIPTION
[1]
connected to this pin can drive a load as small as 5 KΩ. When in record, a resistor connects AUD OUT to the
internal 1.2-volt analog ground supply. This resistor is approximately 850 KΩ, but will vary somewhat according to
the sample rate of the device. This relatively high impedance allows this pin to be connected to an audio bus
without loading it down.
AUD OUT
PIN NAME
V
The AUD OUT pin is always at 1.2 volts when the device is powered up. When in playback, the output buffer
SSA
MOSI
MISO
SS
NC
/ V
SSD
[1]
5-10, 15,
11, 12,
SOIC /
23 / 4
19-22
PDIP
13
1
2
3
PIN NO.
16, 19, 21,
1, 17, 18 /
23, 27, 28
3, 4, 13-
TSOP
10
11
12
20
9
Slave Select: This input, when LOW, will select the
ISD4002 device.
Master Out Slave IN: This is the serial input to the
ISD4002 device when it is configured as slave. The master
microcontroller places data on the MOSI line one half-cycle
before the rising edge of SCLK for clocking into the device.
Master In Slave Out: This is the serial output (open drain)
of the ISD4002 device. This output goes into a high-
impedance state if the device is not selected.
Ground: The ISD4002 series utilizes separate analog and
digital ground busses. The analog ground (V
should be tied together as close as possible and connected
through a low-impedance path to power supply ground.
The digital ground (V
a separate low-impedance path to power supply ground.
These ground paths should be large enough to ensure that
the impedance between the V
less than 3 Ω. The backside of the die is connected to V
through the substrate. For chip-on-board design, the die
attach area must be connected to V
Not connected
Audio Output: This pin provides an audio output of the
stored data and is recommended be AC coupled. It is
capable of driving a 5 KΩ impedance R
- 7 -
Publication Release Date: September 2003
SSD
FUNCTION
) pin should be connected through
ISD4002 SERIES
SSA
pins and the V
SS
or left floating.
EXT
.
SSD
SSA
Revision 1
) pins
pin is
SS