AT32UC3B0128 Atmel Corporation, AT32UC3B0128 Datasheet - Page 442

• Manufacturer Part Number: AT32UC3B0128
• Manufacturer: Atmel Corporation

Specifications of AT32UC3B0128

• Flash (kbytes): 128 Kbytes
• Pin Count: 64
• Max. Operating Frequency: 60 MHz
• Cpu: 32-bit AVR
• # Of Touch Channels: 32
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 44
• Ext Interrupts: 44
• Usb Transceiver: 1
• Usb Speed: Full Speed
• Usb Interface: Device + OTG
• Spi: 4
• Twi (i2c): 1
• Uart: 3
• Ssc: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 384
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 32
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 85
• I/o Supply Class: 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Operating Voltage (vcc): 3.0-3.6 or (1.65-1.95+3.0-3.6)
• Fpu: No
• Mpu / Mmu: Yes / No
• Timers: 10
• Output Compare Channels: 16
• Input Capture Channels: 6
• Pwm Channels: 13
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

22.8.3
22.8.3.1
Register Name:
Access Type:
Offset:
Reset Value:
• RESUME: Send USB Resume
• RESET: Send USB Reset
• SOFE: Start of Frame Generation Enable
32059L–AVR32–01/2012
31
23
15
7
-
-
-
-
Writing a one to this bit will generate a USB Resume on the USB bus.
This bit is cleared when the USB Resume has been sent or when a USB reset is requested.
Writing a zero to this bit has no effect.
This bit should be written to one only when the start of frame generation is enable. (SOFE bit is one).
Writing a one to this bit will generate a USB Reset on the USB bus.
This bit is cleared when the USB Reset has been sent.
It may be useful to write a zero to this bit when a device disconnection is detected (UHINT.DDISCI is one) whereas a USB Reset
is being sent.
Writing a one to this bit will generate SOF on the USB bus in full speed mode and keep alive in low speed mode.
Writing a zero to this bit will disable the SOF generation and to leave the USB bus in idle state.
This bit is set when a USB reset is requested or an upstream resume interrupt is detected (UHINT.RXRSMI).
USB Host Registers
Host General Control Register
30
22
14
6
-
-
-
-
UHCON
Read/Write
0x0400
0x00000000
29
21
13
5
-
-
-
-
28
20
12
4
-
-
-
-
27
19
11
3
-
-
-
-
RESUME
26
18
10
2
-
-
-
RESET
25
17
9
1
-
-
-
SOFE
24
16
8
0
-
-
-
442