ATmega88 Automotive Atmel Corporation, ATmega88 Automotive Datasheet - Page 42

• Manufacturer Part Number: ATmega88 Automotive
• Manufacturer: Atmel Corporation

Specifications of ATmega88 Automotive

• Flash (kbytes): 8 Kbytes
• Pin Count: 32
• Max. Operating Frequency: 16 MHz
• Cpu: 8-bit AVR
• # Of Touch Channels: 12
• Hardware Qtouch Acquisition: No
• Max I/o Pins: 23
• Ext Interrupts: 24
• Usb Speed: No
• Usb Interface: No
• Spi: 2
• Twi (i2c): 1
• Uart: 1
• Graphic Lcd: No
• Video Decoder: No
• Camera Interface: No
• Adc Channels: 8
• Adc Resolution (bits): 10
• Adc Speed (ksps): 15
• Analog Comparators: 1
• Resistive Touch Screen: No
• Temp. Sensor: No
• Crypto Engine: No
• Sram (kbytes): 1
• Eeprom (bytes): 512
• Self Program Memory: YES
• Dram Memory: No
• Nand Interface: No
• Picopower: No
• Temp. Range (deg C): -40 to 150
• I/o Supply Class: 2.7 to 5.5
• Operating Voltage (vcc): 2.7 to 5.5
• Fpu: No
• Mpu / Mmu: no / no
• Timers: 3
• Output Compare Channels: 6
• Input Capture Channels: 1
• Pwm Channels: 6
• 32khz Rtc: Yes
• Calibrated Rc Oscillator: Yes

8.0.2
8.0.3
42
ATmega48/88/168 Automotive
Reset Sources
Power-on Reset
The ATmega48/88/168 has four sources of reset:
Figure 8-1.
A Power-on Reset (POR) pulse is generated by an On-chip detection circuit. The detection level
is defined in
level. The POR circuit can be used to trigger the start-up Reset, as well as to detect a failure in
supply voltage.
A Power-on Reset (POR) circuit ensures that the device is reset from Power-on. Reaching the
Power-on Reset threshold voltage invokes the delay counter, which determines how long the
device is kept in RESET after V
when V
• Power-on Reset. The MCU is reset when the supply voltage is below the Power-on Reset
• External Reset. The MCU is reset when a low level is present on the RESET pin for longer
• Watchdog System Reset. The MCU is reset when the Watchdog Timer period expires and
• Brown-out Reset. The MCU is reset when the supply voltage V
threshold (V
than the minimum pulse length.
the Watchdog System Reset mode is enabled.
Reset threshold (V
BODLEVEL [2..0]
RSTDISBL
CC
decreases below the detection level.
Table 8-1 on page
Reset Logic
POT
).
Pull-up Resistor
FILTER
SPIKE
BOT
) and the Brown-out Detector is enabled.
CC
43. The POR is activated whenever V
CKSEL[3:0]
rise. The RESET signal is activated again, without any delay,
Power-on Reset
Reset Circuit
SUT[1:0]
Brown-out
Watchdog
Oscillator
Generator
Circuit
Clock
CK
Register (MCUSR)
MCU Status
DATA BUS
Delay Counters
CC
is below the Brown-out
CC
TIMEOUT
is below the detection
7530I–AVR–02/10