5-1123723-6 TE Connectivity, 5-1123723-6 Datasheet - Page 5

• Manufacturer Part Number: 5-1123723-6
• Manufacturer: TE Connectivity

Specifications of 5-1123723-6

• Product Line: Economy Power
• Product Type: Connector
• Connector Type: Header
• Pcb Mounting Orientation: Vertical
• Pcb Mount Retention: Without
• Pcb Mount Alignment: Without
• Termination Method To Pc Board: Through Hole - Solder
• Sealed: No
• Mating Retention Type: Latching
• Contact - Rated Current (a): 7.5
• Operating Voltage Reference: AC
• Operating Voltage (vac): 250
• Tail Orientation: In-line
• Tail Length (mm [in]): 3.7 [0.146]
• Profile Height (y-axis) (mm [in]): 8.50 [0.3346]
• Centerline (mm [in]): 3.96 [0.156]
• Header Type: Unshrouded
• Number Of Positions: 6
• Selectively Loaded: No
• Mating Retention: With
• Number Of Rows: 1
• Length (x-axis) (mm [in]): 23.70 [0.9331]
• Width (z-axis) (mm [in]): 10.70 [0.421]
• Contact Type: Pin
• Contact Base Material: Brass
• Contact Plating, Mating Area, Material: Tin
• Contact Plating, Mating Area, Thickness (µm [?in]): 0.8 [31.5]
• Contact Design: Square Post
• Tail Plating Material: Tin
• Tail Plating, Thickness (µm [?in]): 0.8 [31.46]
• Connector Style: Plug
• Housing Material: PBT
• Housing Color: Black
• Mating Alignment: With
• Ul Flammability Rating: UL 94V-0
• Rohs/elv Compliance: RoHS compliant, ELV compliant
• Lead Free Solder Processes: Wave solder capable to 240°C, Wave solder capable to 260°C, Wave solder capable to 265°C
• Rohs/elv Compliance History: Converted to comply with RoHS directive
• Operating Temperature (°c [°f]): -25 – +105 [-13 – +221]
• Applies To: Printed Circuit Board
• Pcb Thickness, Recommended (mm [in]): 1.60 [0.063]
• Contact Transmits (typical Application): Power

4.
4.1.
4.2.
4.3.
4.4.
Rev O5
QUALITY ASSURANCE PROVISIONS
Qualification Testing
A.
B.
Requalification Testing
If changes significantly affecting form, fit or function are made to the product or manufacturing process,
product assurance shall coordinate requalification testing, consisting of all or part of the original testing
sequence as determined by development/product, quality and reliability engineering.
Acceptance
Acceptance is based on verification that the product meets the requirements of Figure 1. Failures
attributed to equipment, test setup or operator deficiencies shall not disqualify the product. If product
failure occurs, corrective action shall be taken and specimens resubmitted for qualification. Testing to
confirm corrective action is required before resubmittal.
Quality Conformance Inspection
The applicable quality inspection plan shall specify the sampling acceptable quality level to be used.
Dimensional and functional requirements shall be in accordance with the applicable product drawing
and this specification.
Specimen Selection
Specimens shall be prepared in accordance with applicable Instruction Sheets and shall be
selected at random from current production. Each test group shall consist of a minimum of 5
specimens.
Test Sequence
Qualification inspection shall be verified by testing specimens as specified in Figure 2.
LLCR Measurement Points
Figure 3
108-2297
5 of 6