MAX4501 Maxim, MAX4501 Datasheet
MAX4501
Available stocks
Related parts for MAX4501
MAX4501 Summary of contents
Page 1
... Low-Voltage, SPST, CMOS Analog Switches _________________General Description The MAX4501/MAX4502 are single-pole/single-throw (SPST), low-voltage, single-supply, CMOS analog switches. The MAX4501 is normally open (NO). The MAX4502 is normally closed (NC). These CMOS switches can operate continuously with a single supply between +2V and +12V. Each switch can ® ...
Page 2
... Plastic DIP (derate 9.09mW/°C above +70°C) ...727mW 8-Pin CERDIP (derate 8.00mW/°C above +70°C)........640mW Operating Temperature Ranges MAX4501C_ _/MAX4502C_ _ .............................0°C to +70°C MAX4501E_ _/MAX4502E_ _ ...........................-40°C to +85°C MAX4501MJA/MAX4502MJA ........................-55°C to +125°C Storage Temperature Range .............................-65°C to +150°C Lead Temperature (soldering, 10s) .................................+300° ...
Page 3
Low-Voltage, SPST, CMOS Analog Switches ELECTRICAL CHARACTERISTICS—+5V Supply (continued) (V+ = +4.5V to +5.5V 2.4V, V INH INL PARAMETER SYMBOL SWITCH DYNAMIC CHARACTERISTICS (continued) Charge Injection (Note 5) Off-Isolation V C NO(OFF Off-Capacitance C NC(OFF) ...
Page 4
... Note 3: Leakage parameters are 100% tested at maximum-rated hot operating temperature, and are guaranteed by correlation at +25°C. Note 4: SOT and SC70 packaged parts are 100% tested at +25°C. Limits at maximum and minimum rated temperature are guaran- teed by design and correlation limits at +25°C. ...
Page 5
... IN/OUT 10 1 0.1 0. 100 1k 10k FREQUENCY (Hz) OFF-LEAKAGE vs. TEMPERATURE 1000 V+ = 5.5V 100 -50 - TEMPERATURE (°C) FREQUENCY RESPONSE MAX4501- ON-PHASE -10 -20 -30 -40 OFF-ISOLATION -50 - +5V -70 50Ω IN/OUT - 100 1000 FREQUENCY (MHz) SWITCHING TIME vs. SUPPLY VOLTAGE 100 ...
Page 6
... TTL guaranteed high-level minimum of 2.8V, but still compatible with CMOS out- puts. Do not connect the MAX4501/MAX4502’s V+ pin to +3V and then connect the logic-level pins to TTL logic-level signals. TTL levels can exceed +3V and violate the absolute maximum ratings, damaging the part and/or external circuits. In 50Ω ...
Page 7
... COM V OUT 1k 35pF OUT V C OUT L 1000pF ∆V OUT ERROR Q WHEN THE CHANNEL TURNS OFF ∆V 50% 90% 90 OFF 50% 90% 90 OFF ON MAX4502 MAX4501 ∆V OUT IS THE MEASURED VOLTAGE DUE TO CHARGE TRANSFER C • OUT L 7 ...
Page 8
... Circuits/Timing Diagrams (continued) 10nF MAX4501 V+ MAX4502 IN COM GND Figure 3. Off-Isolation and On-Loss MAX4501 AS MAX4502 IN COM REQUIRED GND Figure 4. NO, NC, and COM Capacitance Ordering Information (continued) PART TEMP. RANGE PACKAGE MAX4502CUK-T 0°C to +70°C 5 SOT23-5 MAX4502CSA 0°C to +70°C ...