MAX1607 Maxim, MAX1607 Datasheet
MAX1607
Available stocks
Related parts for MAX1607
MAX1607 Summary of contents
Page 1
... MAX1693, but it has a built-in latch that turns off the power switch in case of a long-term short- circuit condition. The MAX1607 is also offered in a 10-pin TDFN package (not pin compatible with Texas Instruments TPS2014, TPS2015, and TPS2041 for USB applications). Notebook Computers ...
Page 2
... OUT Short-Circuit to GND ..........................................Continuous Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent damage to the device. These are stress ratings only, and functional operation of the device at these or any other conditions beyond those indicated in the operational sections of the specifications is not implied. Exposure to absolute maximum rating conditions for extended periods may affect device reliability ...
Page 3
ELECTRICAL CHARACTERISTICS (V = +5V -40°C to +85°C, unless otherwise noted.) (Note PARAMETER SYMBOL OPERATING CONDITION Input Voltage V POWER SWITCH Switch Static Drain-Source R DS(ON) On-State Resistance Switch Turn-On Time t Switch Turn-Off Time ...
Page 4
USB Current-Limited Switch in Pin-Compatible Package (V = +5V +25°C, unless otherwise noted QUIESCENT CURRENT vs. INPUT VOLTAGE GND OUT ...
Page 5
T = +25°C, unless otherwise noted CURRENT-LIMIT AND OC RESPONSE CH1 CH2 CH3 CH4 2ms/div CH1 = V , 200mV/div, AC-COUPLED IN CH2 = V , 5V/div OUT CH3 = V , 5V/div OC CH4 ...
Page 6
... If the fault short-circuit condi- tion is not removed, the switch will cycle on and off, resulting in a pulsed output. 1.24V The MAX1607 provides an overcurrent output (OC). A 100kΩ pull-up resistor from provides a logic control signal. This open-drain output goes low when GND any of the following conditions occur: • ...
Page 7
... If the load fault persists beyond the 10ms overcurrent-blanking timeout, the OC output asserts low. Ensure that the MAX1607 input is ade- quately bypassed to prevent input glitches from trigger- ing spurious OC outputs. Input voltage glitches less than 150mV will not cause a spurious OC output. Load- transient faults less than 10ms (typ) will not cause an OC output assertion ...
Page 8
... USB Current-Limited Switch in Pin-Compatible Package (The package drawing(s) in this data sheet may not reflect the most current specifications. For the latest package outline information www.maxim-ic.com/packages TOP VIEW FRONT VIEW 8 _______________________________________________________________________________________ 0∞-8∞ L SIDE VIEW ...
Page 9
... For the latest package outline information www.maxim-ic.com/packages.) _______________________________________________________________________________________ USB Current-Limited Switch in Pin-Compatible Package Package Information (continued) 9 ...
Page 10
... Pages changed at Rev 7–10 Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. ...