NSVS682 New Japan Radio Co.,Ltd, NSVS682 Datasheet - Page 3

• Manufacturer Part Number: NSVS682
• Description: Jrc Saw Filter
• Manufacturer: New Japan Radio Co.,Ltd

Notice
Note
1. This specification specifies the quality of this component as a single unit. Make
1. Use this component within operating temperature range. It might not be
2. When soldering iron is used, solder with the temperature at the tip of soldering
3. Notice that the allowed time of soldering with soldering iron is accumulated
4. As rapid temperature change for cleaning after reflow soldering might be a
5. Confirm that there are not any influence for qualification to this component in
6. As it might be a cause of degradation of destruction to apply static electricity to
7. As it might be a cause of degradation or destruction to apply D.C. voltage
sure that this component is evaluated and confirmed against this specification
when it is mounted to your products.
satisfied with electrical specification without operating temperature range.
When it is used less than -20ºC or more than +70ºC, it might be a cause of
degradation or destruction of the component. Even if it endures during a short
time, it causes degradation of qualification.
iron: 350ºC max., the time of soldering: 10 seconds max., the power of
soldering iron: 30W max..
time, when soldering is repeated.
cause of destruction clean this component after confirming that temperature of
this component goes down to room temperature.
mounting on PCB when this component is cleaned.
this component, do not apply static electricity or excessive voltage while
assembling and measuring. And do not transport this component with bare
hand.
between each terminal, apply D.C. voltage 7.5V max. in actual circuit.
NSVS682 Dec-01