FX613 Consumer Microcircuits Limited, FX613 Datasheet - Page 2

• Manufacturer Part Number: FX613
• Description: Universal Call Progress Decoder
• Manufacturer: Consumer Microcircuits Limited

Pin Number
FX613DW
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
9
FX613P
10
11
12
13
14
1
2
3
4
5
6
7
8
9
Xtal/Clock: The input to the on-chip clock oscillator inverter. A 3.579545MHz Xtal or
externally derived telephone system clock (f
Note - The operation of the FX613 without a suitable Xtal/Clock input may cause
device damage.
Xtal: The output of the on-chip clock oscillator inverter. See Figure 2.
No internal connection.
V
Level In: The input for level discrimination. This input is internally biased to V
signals must be a.c. coupled. The audio signal must be fed to both this pin and the
Signal In pin. Correct level detection determines the operation of this device (see
Principles of Decoder Operation), however to disregard the amplitude of the input
levels the FX613 may be permanently enabled by pulling this pin to V
by pulling to V
Signal In: The input for frequency discrimination and decoding. This input is internally
biased to V
pin and the Level In pin.
No internal connection.
V
No internal connection.
No internal connection.
IRQ: This Interrupt Request output from the FX613 is ‘wire-OR able’ allowing the
interrupt outputs of other peripherals to be combined and connected to the Interrupt
input of a µProcessor. This input has a low-impedance pulldown to V
a high-impedance when inactive. An interrupt is produced on completion of a HI or LO
frequency measurement.
Serial Clock: The serial clock from the µProcessor. Data Out is clocked into the
µProcessor on the rising edge of the Serial Clock. See Data-Read Timing diagram.
Chip Select: A logic “0” at this input will select this device.
Data Out: The serial data output. Under the control of the Chip Select and Serial
Clock inputs, data should be read from this output in 6-bit blocks MSB (Bit-5) first.
If 8 serial clock pulses are applied, two additional logic “0s” will be output after Bit-0.
No internal connection.
V
the FX613 are dependent upon this supply. This pin should be decoupled to V
capacitor located close to the FX613 pins.
BIAS
SS
DD
: Negative supply rail. Signal ground.
: Positive supply rail. A single, stable supply is required. Levels and voltages within
: The internal circuitry bias line, held at V
BIAS
SS
, signals must be a.c. coupled. The audio signal must be fed to both this
.
2
Function
XTAL
DD
) should be connected here.
/2 this pin must be decoupled to V
SS
DD
when active and
and disabled
BIAS
SS
by a
,
SS
.