DF12C-20DP-0.5V Hirose Electric, DF12C-20DP-0.5V Datasheet - Page 11

• Manufacturer Part Number: DF12C-20DP-0.5V
• Description: 0.5mm Pitch SMT Board to Board Connector
• Manufacturer: Hirose Electric

BPrecautions for Use
1.Recommended Temperature Profile (SMT)
2.Recommended Manual Soldering Condition (SMT) Soldering iron temperature: 290 10 , Soldering time: Within 2 seconds
3.Recommended Screen Thickness (SMT) 0.12mm
4.Board Warp(SMT)
5.Cleaning Condition
6.Cautions
Note 1 : Maximum twice action is allowed under the same condition. However, the interval
Note 2 : The temperature indicates the board surface temperature In the connector lead area.
When the 0.15mm thickness is used, set the metal mask open area to 85% as a target.
Maxmum 0.02mm in the connector center area, based on both connector edges
Refer to "Nylon Connector Use Hand book".
The receptacle is designed in a structure where contacts are exposed. Touching it with
bare hands would cause contact failure or electrostatic element damage.
Where no board is mounted, the insertion or extraction will cause damage or
contact deformation.
Avoid retaining the board with the connector only, and fix the board by any other means
than the connector.
Excessive scoop insertion or extraction may result in damage.
In the manual soldering process, don't carry out the flux coating which will cause a flux
blister on the connector.
The color phase of this product may be slightly different from that of the formed product
according to the manufacturing lot. However, the difference doesn't affect the performance.
between the first and second actions must be maintained at the room temperature.
A307