MSA-TE-4 Banner Engineering Corp., MSA-TE-4 Datasheet - Page 3

• Manufacturer Part Number: MSA-TE-4
• Description: For Mini-screen Sensors Mounted In Washdown Environments
• Manufacturer: Banner Engineering Corp.

Figure 3. MSA-TE Series Tubular Enclosure assembly steps
A
C
E
G
I
Banner Engineering Corp.
www.bannerengineering.com • Tel: [phone]
Lockwasher
•
Minneapolis, MN U.S.A.
D
H
B
F
J
O-ring
(backside)
MSA-TE Series Tubular Enclosures
A.Place spacer disk on the QD end of the MINI-SCREEN sensor,
B.Screw the top cap onto the non-QD end of the MINI-SCREEN
C.Being careful not to scratch the tubular housing, slide the
D.Connect the cordset to the MINI-SCREEN.
E. Slide the MINI-SCREEN into the clear tube until the top cap
F. Screw the top cap to the tube flange using four 6-32 screws
G.Slide the bottom end cap over the unterminated end of the
H.Screw the bottom cap to the tube flange, using four 6-32
I. Place the mounting bracket on the top cap and secure with
J. Place the mounting bracket over the cordset cable and to
using the plastic mounting nut and lockwasher (supplied with
MINI-SCREEN).
using the two M4 screws and lockwashers (make sure o-ring
is in place on top cap). Torque: 6 in-lbs max.
terminated end of the cordset into the labeled end of the clear
tube and push it through, so it comes out the other end.
mates with the tube flange. Make sure the o-ring seals against
the flat surface of the flange.
and lockwashers. Torque: 15 in-lbs max.
cordset, making sure the o-ring is in place on the bottom cap.
screws and lockwashers. Make sure the o-ring seals against
the flat surface of the flange. Torque: 15 in-lbs max. Tighten
the strain relief nut over the cordset cable.
two 10-32 screws and lockwashers. Torque: 50 in-lbs max.
the bottom end cap; secure with two 10-32 screws and
lockwashers. Torque: 50 in-lbs max.
Assembly Instructions
P/N 109307 rev. B
3