MAX1705 Maxim, MAX1705 Datasheet - Page 9

• Manufacturer Part Number: MAX1705
• Description: 1- to 3-Cell / High-Current / Low-Noise / Step-Up DC-DC Converters with Linear Regulator
• Manufacturer: Maxim

Step-Up DC-DC Converters with Linear Regulator
______________________________________________________________Pin Description
PIN
10
11
12
13
14
15
16
1
2
3
4
5
6
7
8
9
CLK/SEL
TRACK
FBLDO
NAME
PGND
POUT
GND
ONB
ONA
OUT
LDO
LBO
LBN
LBP
REF
FB
LX
_______________________________________________________________________________________
Low-Battery Comparator Noninverting Input. Common-mode range is 0.5V to 1.5V.
Low-Battery Comparator Inverting Input. Common-mode range is 0.5V to 1.5V.
1.250V Reference Output. Bypass REF with a 0.33µF capacitor to GND. REF can source up to 50µA.
Track-Mode Control Input for DC-DC Converter. In track mode, the boost-converter output is sensed at
OUT and set 0.3V above LDO to improve efficiency. Set TRACK to OUT for track mode. Connect TRACK to
GND for normal operation.
Ground
Step-Up Converter Feedback Input, used during track mode. IC power and low-dropout linear-regulator
input. Bypass OUT to GND with a 0.1µF ceramic capacitor placed as close to the IC as possible.
Step-Up DC-DC Converter Feedback Input. Connect FB to a resistor voltage divider between POUT and
GND to set the output voltage between 2.5V and 5.5V. FB regulates to 1.233V.
Low-Dropout Linear-Regulator Feedback Input. Connect FBLDO to a resistor voltage divider between LDO
to GND to set the output voltage from 1.25V to V
Low-Dropout Linear-Regulator Output. LDO sources up to 200mA. Bypass to GND with a 22µF capacitor.
Low-Battery Comparator Output. This open-drain, N-channel output is low when LBP < LBN.
Input hysteresis is 16mV.
Switching-Mode Selection and External-Clock Synchronization Input:
• CLK/SEL = low: low-power, low-quiescent-current PFM mode.
• CLK/SEL = high: low-noise, high-power PWM mode. Switches at a constant frequency (300kHz). Full
• CLK/SEL = driven with an external clock: low-noise, high-power synchronized PWM mode.
Turning on the DC-DC converter with CLK/SEL = GND also serves as a soft-start function,
since peak inductor current is reduced.
Power Ground for the source of the N-channel power MOSFET switch
Inductor connection to the drains of the P-channel synchronous rectifier and N-channel switch
Off Control Input. When ONB = high and ONA = low, the IC is off. Connect ONB to GND for normal
operation (Table 2).
On Control Input. When ONA = high or ONB = low, the IC turns on. Connect ONA to OUT for normal
operation (Table 2).
Boost DC-DC Converter Power Output. POUT is the source of the P-channel synchronous-rectifier MOSFET
switch. Connect an external Schottky diode from LX to POUT. The output current available from POUT is
reduced by the current drawn from the LDO linear-regulator output.
output power is available.
Synchronizes to an external clock (from 200kHz to 400kHz).
1- to 3-Cell, High-Current, Low-Noise,
FUNCTION
OUT
- 0.3V (5.0V max). FBLDO regulates to 1.250V.
9