MD3331-D64-V3 M-Systems Inc., MD3331-D64-V3 Datasheet - Page 20

• Manufacturer Part Number: MD3331-D64-V3
• Description: Diskonchip Millennium Plus
• Manufacturer: M-Systems Inc.

The following abbreviations are used:
IN
ST
OD
R8
R
Note: For forward compatibility with future DiskOnChip 7x10 BGA products, additional pads are required. Please
20
RSRVD
Signal
-
-
refer to Application Note AP-DOC-067, Preparing your PCB Footprint for the DiskOnChip BGA Migration
Path, for detailed information.
Standard (non-Schmidt) input
Schmidt Trigger input
Open drain
Nominal 22 KΩ pull-up resistor, enabled only for 8-bit interface mode (IF_CFG input is 0)
3.7 MΩ nominal pull-up resistor
Other. See
Ball No.
Figure 5
K6
M
A
Input
Type
-
-
-
-
Reserved signal that is not connected internally.
Note: Future DiskOnChip devices will use this pin as a clock input. To be
forward compatible, this pin can already be connected to the system CLK
or to VCC when the clock input feature is not required.
Reserved signal that is not connected internally and must be left
floating to guarantee forward compatibility with future products. It
should not be connected to arbitrary signals.
Mechanical. These balls are for mechanical placement, and are
not connected internally.
Alignment. This ball is for device alignment, and is not connected
internally.
Data Sheet, Rev. 1.7
Mechanical
Reserved
Description
DiskOnChip Millennium Plus 16/32/64MByte
93-SR-002-03-8L
Signal
Type