2458-000-G911-9 BTC Electronic Components, 2458-000-G911-9 Datasheet - Page 15

• Manufacturer Part Number: 2458-000-G911-9
• Description: Ssmc Connectors
• Manufacturer: BTC Electronic Components

Available from
BTC Electronic Components, Inc.
1) Trim cable as shown.
2) Soft solder cable jacket to backnut, making sure that end of cable is flush with front side
3) Insert prepared cable into back of body. Slide nut forward and tighten to 25-50 inch ounces
Remove any burrs from
jacket and
center conductor.
of backnut. Slide insulator over cable dielectric until it is flush with front of backnut.
Slide contact onto center conductor, with contact shoulder flush with front of insulator.
Solder contact to center conductor.
torque.
Code
DELTA ELECTRONICS MANUFACTURING
D/01
Trim Codes
.059
A
( 978 ) 927-1060
.050
B
.125
SSMC Cable Assembly Instructions
•
Assembly Procedure D
Assembly Procedure C
1-800-526-2828 or 919-556-8900
FAX ( 978 ) 922-6430
1) Trim cable as shown.
Remove any burrs
from jacket and
center conductor.
B
A
•
www.deltarf.com
2) Soft solder cable jacket to body, making sure
Cable end flush with step
that end of cable is flush with step in body.
Solder center conductor into contact slot,
assemble insulator disc (if supplied), then press
cap into body until seated or screw into place.
Soft solder
all around
Solder
Body assembly
www.btcelectronics.com
Press cap in
until seated
Backnut
Solder center
conductor to
contact
Insulator
(if supplied)
Cap
Solder
15