NJM2671 JRC, NJM2671 Datasheet - Page 4

• Manufacturer Part Number: NJM2671
• Description: Stepper Motor / DIP16-D2 / EMP16-E2
• Manufacturer: JRC

www.DataSheet4U.com
NJM2671
- 4 -
TYPICAL APPLICATION
Function description
Logic input
winding.
combined with a pulse generator.
being exceeded, which is a common problem with unipolar winding systems and also simplifies the design of
power control circuits during phase turn off.
level. The NJM2671 has built-in phase logic for optimum control of the stepping motor.
STEP – Stepping pulse
DIR – direction
HSM – half/full step mode switching
The NJM2671 is a high-performance low-voltage driver system for driving stepping motors with unipolar
Employing a general-purpose STEP&DIR motion controller, it can easily control a stepping motor when
The phase output is as high as 60 V max. This prevents the phase output voltage margin of the motor from
All inputs are LS-TT compatible. When the logic input is open, the circuit recognizes any open logic inputs as H
mode, the pulse turns the stepping motor at the basic step angle. In half step mode, two pulses are required to
turn the motor at the basic step angle.
therefore be established before the start of the negative edge. Note the setup time ts in Figure 4.
NJM2671 is connected to the motor. Although DIR can be modified this should be avoided since a misstep of
1 pulse increment may occur if it is set simultaneous with the negative edge. See the timing chart in Figure 4.
logic is set to the half step mode when HSM is low level. Although HSM can be modified this should be
avoided since a misstep of 1 pulse increment may occur if it is set simultaneous with the negative edge. See
VMM
+5V
The built-in phase logic sequencer goes UP on every negative edge of the STEP signal (pulse). In full step
The DIR (direction) signal and HSM (half/full mode) are latched to the STEP negative edge and must
The DIR signal determines the step direction. The direction of the stepping motor depends on how the
This signal determines whether the stepping motor turns at half step or full step mode. The built-in phase
HALF/FULL STEP
IInput/Output Device
NORMAL/INHBIT
CMOS,TTL-LS
GND(VCC)
OPTIONAL
SENSOR
CW/CCW
RESET
STEP
GND
C=4,700pF
MO
STEP
DIR
HSM
RESET
INH
B
A
NJM2671
VCC
C 10 F
Fig.3
C 10 F
GND(VMM)
GND
PB2
PB1
PA2
PA1
R1
11DF2or31DF
Japan Inter
MOTOR
D1-D4
R2
Ver.2004-09-25